593325
50
Zoom out
Zoom in
Previous page
1/66
Next page
50
CLP-950/930
6 x 16 mm flat-head screws 3
6 x 16 mm Senkschrauben 3
Vis à tête plate de 6 x 16 mm 3
Tornillos de cabeza plana de 6 x 16 mm 3
A
3
C
Montieren Sie die Tastatureinheit (A).
Setzen Sie die Tastatureinheit (A) so auf den fertigen Ständer,
daß die beiden Schrauben an ihrer Unterseite hinter den Winkel-
blechen mit Führungsschlitz an der Hinterseite des Ständers zu
liegen kommen. Schieben Sie die Tastatureinheit dann bis zum
Anschlag in die Schlitze. KLEMMEN SIE IHRE FINGER
DABEI NICHT EIN!!
Richten Sie die Schraubenbohrungen an der Unterseite der
Tastatureinheit mit den Bohrungen der Winkelbleche aus
(achten
Sie auch darauf, daß sie mittig auf dem Ständer steht, wie in der
Abbildung gezeigt), um die Tastatureinheit dann mit den vier 6 x
16 mm Senkschrauben 3 festzuschrauben. Die vier Schrauben
können von der Rückseite her eingeführt werden.
VORSICHT
Halten Sie die Tastatureinheit nur wie in der obigen Abbildung!
Achten Sie darauf, daß Sie Ihre Finger nicht zwischen Tastatur-
einheit und den Seitenwänden bzw. der Rückwand einklemmen —
die Tastatureinheit könnte dadurch zu Fall kommen!
V
Schließen Sie das Lautsprecherkabel an.
Das vom Lautsprecher kommende Kabel wird an die entspre-
chende Buchse an der Tastatrureinheit angeschlossen. Der Kabel-
stecker paßt nur in einer Ausrichtung in die Buchse (mit der
Führungsnase zur Rückseite des Instruments weisend, wie in der
Abbildung verdeutlicht). Versuchen Sie nicht, den Stecker falsch
herum mit Gewalt in die Buchse zu drücken!
B
Schließen Sie das Pedalkabel an.
Das vom Pedalkasten kommende Pedalkabel wird an die PE-
DAL-Buchse hinten an der Unterseite der Tastatureinheit ange-
schlossen. Bringen Sie nach dem Anschluß die Kabelhalter an der
Seitenwand an, um das Kabel dann in diese Halter zu klemmen.
C
Install the main unit (A).
Place the main unit (A) on the side panels (B) with the screws
on its bottom panel (toward the rear of the main unit) just behind
the grooves in the brackets located at the top of the side panels.
Then slide the main unit forward until it stops. WATCH YOUR
FINGERS WHEN DOING THIS!!
Align the holes on the bottom panel of the main unit with the
holes in the brackets on the side panels
(also center the main unit
to produce equal clearance on the left and right sides, as shown in
the illustration), then use the four 6 x 16 millimeter flat-head
screws 3 to attach the main unit. The four screws can be at-
tached from the rear.
CAUTION
Do not hold the keyboard in any position other than the position
shown in the above illustration.
Fingers can become pinched between the main unit and the rear or
side panels, be extra careful so as not to drop the main unit.
V
Connect the speaker cord.
The speaker cord from the speaker box must be plugged into
the corresponding connector in the main unit. The plug only goes
in one way (the lug on the connector should face the rear of the
main unit, as shown in the illustration), so don’t try to force it in
the wrong way around.
B
Connect the pedal cord.
The pedal cord from the pedal box must be plugged into the
PEDAL connector located at the rear of the main unit’s under-
side. Once connected, attach the cord holders to the side panel as
shown, then clip the cord into the holders.
10 cm
Be sure to place your hands at least 10 centimeters from
either end of the main unit when positioning it.
Mindestens 10 cm innen unter die Tastatureinheit greifen.
Placez bien vos mains à 10 cm au moins des extrémités
du clavier, lors de sa mise en place.
Asegúrese de colocar las manos por lo menos a 10
centímetros desde los extremos de la unidad principal
cuando la sitúe.
10 cm
The bracket on the front has 2 holes. Insert the screws into
the holes on the front panel side of the bracket.
Die vorderen Winkelbleche haben zwei
Schraubenbohrungen. Führen Sie die Schraube jeweils in
die Bohrung an der Stirnwandseite ein.
La partie avant de la ferrure comporte deux trous.
Introduisez les vis de fixation dans les trois du côté du
panneau avant de la ferrure.
La ménsula de la parte frontal tiene 2 orificios. Inserte los
tornillos en los orificios del lado del panel frontal de la
ménsula.
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CLP-950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CLP-950 in the language / languages: French as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CLP-950

Yamaha CLP-950 User Manual - English - 20 pages

Yamaha CLP-950 User Manual - English - 66 pages

Yamaha CLP-950 User Manual - German - 66 pages

Yamaha CLP-950 User Manual - Dutch - 64 pages

Yamaha CLP-950 User Manual - Danish - 62 pages

Yamaha CLP-950 User Manual - Italian - 57 pages

Yamaha CLP-950 User Manual - Portuguese - 32 pages

Yamaha CLP-950 User Manual - Swedish - 60 pages

Yamaha CLP-950 User Manual - Spanish - 66 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info