593318
56
Zoom out
Zoom in
Previous page
1/72
Next page
56
CLP-880/860/840/820/820S
1
The CLP-860/840/820 all require the same assembly
procedures. Illustrations use the CLP-860 for reference.
Be careful not to confuse parts, and be sure to install all parts in the
correct direction. Please assemble in accordance with the sequence
given below.
Assembly should be carried out by at least two persons.
Be sure to use the correct screw size, as indicated above. Use of
incorrect screws can cause damage.
Be sure to tighten up all screws upon completing assembly of each
unit.
To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready.
Z
Open the box and remove all the parts.
On opening the box you should find the parts shown in the
illustration. Check to make sure that all the required parts are
provided.
X
Assemble the side panels (D) and feet (E).
Secure the feet (E) to the side panels (D) with the 5 x 40
millimeter long gold-colored screws 1 (3 each).
Depending on the unit type, the feet (E) may or may not have
cutouts. If the feet have cutouts, make sure that the cutouts on the
feet face the bracket side of the side panels.
C
Attach the side panels (D) to the pedal box
(C).
Before installing the pedal box, untie and straighten out the
bundled cord attached to the bottom of the pedal box. Don’t dis-
card the vinyl tie, you’ll need it later in step N.
Place the pedal box on top of the brackets attached to the side
panels (D), and attach using the four 6 x 20 millimeter round-
head screws 2 — two screws on each side. Make sure the pedals
extend in the same direction as the feet.
Die Modelle CLP-860/840/820 werden auf dieselbe Weise
zusammengebaut. In den Abbildungen wird zur Veranschauli-
chung das Modell CLP-860 gezeigt.
Achten Sie darauf, die Teile nicht zu verwechseln, und installieren Sie alle Teile in
der richtigen Ausrichtung. Gehen Sie beim Zusammenbau bitte in der angegebenen
Reihenfolge vor.
Die Montage sollte von mindestens zwei Personen vorgenommen werden.
Achten Sie darauf, die richtige Schraubengröße zu verwenden, wie es oben gezeigt
ist. Die Verwendung der falschen Schrauben kann zu Schäden führen.
Achten Sie während der Montage darauf, bei jedem Arbeitsgang alle Schrauben
festzuziehen.
Für die Demontage muß die angegebene Reihenfolge umgekehrt befolgt werden.
Sie benötigen einen Kreuzschlitzschraubendreher (+).
Z
Öffnen Sie den Karton und nehmen Sie alle Tei-
le heraus.
Im Karton sollten die oben abgebildeten Teile enthalten sein. Prüfen
Sie zunächst bitte, ob alle Teile vollständig vorhanden sind.
X
Schrauben Sie die Seitenwände (D) und die
Füße (E) zusammen.
Befestigen Sie die Füße (E) mit den vier langen goldenen Schrau-
ben (5 x 40 mm) 1 (jeweils 3 Schrauben) an den Seitenwänden (D).
Die Füße (E) weisen je nach Ausführung einen Ausschnitt auf. Ist
ein solcher Ausschnitt vorhanden, achten Sie beim Zusammenbau
darauf, daß die Ausschnitte der Füße in Richtung der Halterungen an
den Seitewänden weisen.
C
Befestigen Sie die Seitenwände (D) am Pedal-
kasten (C).
Bevor Sie den Pedalkasten montieren, nehmen Sie zunächst das
gebündelte Kabel aus dem Pedalkasten, entfernen den Kabelbinder und
ziehen das Kabel dann gerade aus. Werfen Sie den Kabelbinder nicht
wg, er wird in Schritt N wieder gebraucht.
Setzen Sie den Pedalkasten auf die Winkelbleche der beiden Seiten-
wänden (D), und schrauben Sie ihn dann mit den vier Halbrund-
schrauben (6 x 20 mm) 2 fest (jeweils zwei Schrauben links und
rechts). Achten Sie dabei darauf, daß die Pedale in dieselbe Richtung
weisen wie die vorspringenden Teile der Füße.
CLP-860/840/820:
Zusammenbau und Aufstellung
CLP-860/840/820:
Keyboard Stand Assembly
5 x 40 mm long gold screws
Lange goldene Schrauben
(5 x 40 mm)
Vis longues dorées de 5 x 40 mm
Tornillos dorados largo
de 5 x 40 mm
6 x 20 mm round-head screws
6 x 20 mm Halbrundschrauben
Vis à tête ronde de 6 x 20 mm
Tornillos de cabeza redonda
de 6 x 20 mm
4 x 12 mm round-head screws
4 x 12 mm Halbrundschrauben
Vis à tête ronde de 4 x 12 mm
Tornillos de cabeza redonda
de 4 x 12 mm
4 x 20 mm tapping screws
4 x 20 mm Schneidschrauben
Vis auto-taraudeuses 4 x 20 mm
Tornillos de autoenrosque de
4 x 20 mm
6 x 16 mm flat-head screws
6 x 16 mm Senkschrauben
Vis à tête plate de 6 x 16 mm
Tornillos de cabeza plana de
6 x 16 mm
Bundled pedal cord inside
Gebündeltes Pedalkabel
Cordon de pédalier enroulé à l’intérieur
Cable de pedales enrollado en el interior
DD
A
B
C
EE
x 6 1
x 4 2
x 2 3
x 4 4
x 4 5
Cord holders x 2
Kabelhalter x 2
Serre-câble x 2
Soportes de cable x 2
AC power cord
Netzkabel
Cordon d’alimentation
Cable de alimentación de CA
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CLP-860M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CLP-860M in the language / languages: French as an attachment in your email.

The manual is 1,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CLP-860M

Yamaha CLP-860M User Manual - English - 72 pages

Yamaha CLP-860M User Manual - German - 72 pages

Yamaha CLP-860M User Manual - Dutch - 69 pages

Yamaha CLP-860M User Manual - Portuguese - 46 pages

Yamaha CLP-860M User Manual - Spanish - 72 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info