593318
50
Zoom out
Zoom in
Previous page
1/72
Next page
50
CLP-880/860/840/820/820S
4 5
V
Montieren Sie die Stirnwand (E).
Die Stirnwand wird am vorderen Ende des Pedalkastens und
der Seitenwände angebracht. Setzen Sie die Stirnwand an, und
achten Sie darauf, daß diese bündig an den Seitenwänden anliegt.
Bringen Sie die
kleinen Bohrungen der sechs Halterungen mit
denen in der Stirnwand aus, und schrauben Sie die Stirnwand mit
den sechs 4 x 12 mm Halbrundschrauben 3 fest.
B
Montieren Sie die Tastatureinheit (A).
Setzen Sie die hintere Kante der Tastatureinheit (A) auf die
vorderen Kanten der Ausschnitte in den Seitenwänden (B), und
schieben Sie die Tastatureinheit bis zum Anschlag nach hinten
(
zwischen den Seitenwänden der Tastatureinheit und dem Ständer
darf kein Zischenraum vorhanden sein, wie in Abbildung “a”
gezeigt). KLEMMEN SIE IHRE FINGER DABEI NICHT
EIN!
Da es zwischen Tastatureinheit und Seitenwänden ein wenig
horizontales Spiel gibt, richten Sie die Tastatureinheit mittig aus,
wie in Abbildung “b” gezeigt, und schrauben Sie dann mit den
vier 6 x 16 mm Halbrundschrauben 5 fest. Zwei Schrauben
werden von der Vorderseite her eingeführt, die beiden anderen
von der Rückseite her.
Halten Sie die Tastatureinheit nur wie in der obigen Abbildung!
Achten Sie darauf, daß Sie Ihre Finger nicht zwischen Tastatur-
einheit und der Stirnwand bzw. den Seitenwänden einklemmen —
die Tastatureinheit könnte dadurch zu Fall kommen!
N
Schließen Sie das Lautsprecherkabel an.
Das vom Lautsprecher kommende Kabel wird an die entspre-
chende Buchse an der Tastatrureinheit angeschlossen. Der Kabel-
stecker paßt nur in einer Ausrichtung in die Buchse (mit der
Führungsnase zur Rückseite des Instruments weisend, wie in der
Abbildung verdeutlicht). Versuchen Sie nicht, den Stecker falsch
herum mit Gewalt in die Buchse zu drücken!
V
Attach the front panel (E).
The front panel attaches to the front end of the pedal box and
side panels. Fit the front panel into position and eliminate any
gaps between the front and side panels. Align the
small hole in
each six brackets and attach the front panel using the six 4 x 12
millimeter round-head screws 3.
B
Install the main unit (A).
Rest the rear edge of the main unit (A) on the front edges of
the cutouts in the side panels (B), then slide the main unit back-
ward firmly until it stops (
so that there is no clearance between
the main unit side panels and the stand, as shown in illustration
“a”). WATCH YOUR FINGERS WHILE DOING THIS!!
There is slight horizontal play between the main unit and side
panels, so center the main unit, as shown in illustration “b”, then
use the four 6 x 16 millimeter flat-head screws 5 to attach the
main unit. Two screws can be attached from the front side and
two screws from the rear.
Do not hold the keyboard in any position other than the position
shown in the above illustration.
Fingers can become pinched between the main unit and the front or
side panels, be extra careful so as not to drop the main unit.
N
Connect the speaker cord.
The speaker cord from the speaker box must be plugged into
the corresponding connector in the main unit. The plug only goes
in one way (the lug on the connector should face the rear of the
main unit, as shown in the illustration), so don’t try to force it in
the wrong way around.
E
10 cm
Be sure to place your hands at least 10 centimeters from
either end of the main unit and position the unit so that it
rests 15 centimeters from the front end of the side panels.
Die Tastatureinheit mit den Händen mindestens 10 cm von
beiden Enden entfernt halten und etwa 15 cm hinter der
Vorderkante der Seitenwände aufsetzen.
Placez bien vos mains à 10 cm au moins de l’une des
extrémités du clavier lors de sa mise en place et faire en
sorte que le clavier repose à 15 centimètres du bord avant
des panneaux latéraux.
Asegúrese de colocar las manos por lo menos a 10
centímetros desde los extremos de la unidad principal y
sitúe la unidad de modo que se apoye 15 centímetros desde
el extremo frontal de los paneles laterales.
4 x 12 mm round-head screws 3
4 x 12 mm Halbrundschrauben 3
Vis à tête ronde de 4 x 12 mm 3
Tornillos de cabeza redonda de 4 x 12 mm 3
B
B
10 cm
15 cm
15 cm
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CLP-860M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CLP-860M in the language / languages: French as an attachment in your email.

The manual is 1,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CLP-860M

Yamaha CLP-860M User Manual - English - 72 pages

Yamaha CLP-860M User Manual - German - 72 pages

Yamaha CLP-860M User Manual - Dutch - 69 pages

Yamaha CLP-860M User Manual - Portuguese - 46 pages

Yamaha CLP-860M User Manual - Spanish - 72 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info