590832
59
Zoom out
Zoom in
Previous page
1/71
Next page
56
65
5 Install backboard (D).
Rest the bottom of backboard (D) on the leg ledges (on
both sideboards), and pivot the top of the board into place.
Fasten the upper part of the backboard to the two side-
boards using the short roundhead screws 5. Fasten the
lower part of the backboard in four places using the
tapered screws 4.
6 Install main unit (A).
Lift the main unit, holding it on the bottom as shown in
the diagram. Be sure to grasp the board at least 4 inches
(10 cm) away from the sides. Slide the unit onto the
sideboards from the front, and continue sliding until it is
all the way back.
NOTE
Be careful to avoid snagging your hands or clothes when
installing the main unit.
7 Fasten main unit (A) into place.
First check from the sides to confirm that there is no gap.
Then move to the back and check the gaps between the
main unit and the right and left sideboards. Adjust so that
these gaps are equivalent, and fasten in place (at both ends
of the rear side) with two of the wide flathead screws 2.
Next, move to the front and screw in the two thin flathead
screws 3, and then the remaining two flathead screws 2.
CLP-811/611
CLP-811 Assembly Procedure/Montage des CLP-811/CLP-811 Montage Procédure/Montaje del modelo CLP-811
5 Bringen Sie die Rückseite (D) an.
Setzen Sie die Unterkante der Rückseite (D) auf die Fußvor-
sprünge (auf beiden Seitenteilen), und kippen Sie die Oberkante
der Rückseite an die Haupteinheit. Befestigen Sie die Oberkante
der Rückseite mit den kurzen Rundkopfschrauben 5 an den
beiden Seitenteilen. Befestigen Sie den unteren Teil der Rückseite
an vier Stellen mit den vier Senkkopfschrauben 4.
6 Montieren Sie die Haupteinheit (A).
Heben Sie die Haupteinheit an, indem Sie darunter greifen, wie in
der Abbildung gezeigt. Achten Sie darauf, das Teil mindestens 10
cm von den Seiten entfernt zu greifen. Schieben Sie die Einheit
von vorne auf die Seitenteile, bis sie ganz hinten anschlägt.
HINWEIS
Achten Sie darauf, daß Sie während der Installation der Haupteinheit nicht
Ihre Hände oder Ihre Kleidung verletzen.
7 Befestigen Sie die Haupteinheit (A).
Überprüfen Sie von der Seite, daß keine Lücke zu sehen ist.
Überprüfen Sie dann von hinten aus den Spalt zwischen der
Haupteinheit und den linken und rechten Seitenteilen. Richten
Sie die Haupteinheit so aus, daß beide Abstände gleich sind, und
schrauben Sie die Haupteinheit an den beiden Enden der
Rückseite mit zwei breiten Flachkopfschrauben 2 fest.
Schrauben Sie dann an der Vorderseite die beiden dünnen
Flachkopfschrauben 3 und die beiden übrigen Flachkopf-
schrauben 2 fest.
Four tapered screws 4
Vier Senkkopfschrauben 4
Quatre vis pointues 4
Cuatro tornillos cónicos 4
(420mm)
Two short roundhead screws 5
Zwei kurze Rundkopfschrauben 4
Deux petites vis à tête ronde 4
Dos tornillos cortos de cabeza redonda 4
(412mm)
At least 4 inches(10 cm)
Mindestens 10 cm
Minimum 10 cm
Mínimo 10 cm
59


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CLP-611 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CLP-611 in the language / languages: Spanish as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CLP-611

Yamaha CLP-611 User Manual - English - 72 pages

Yamaha CLP-611 User Manual - German - 71 pages

Yamaha CLP-611 User Manual - French - 71 pages

Yamaha CLP-611 User Manual - Portuguese - 56 pages

Yamaha CLP-611 User Manual - Swedish - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info