590512
29
Zoom out
Zoom in
Previous page
1/39
Next page
5
B
Attach the speaker box (B) to the side
panels (E).
Before attaching the speaker box, remove the speaker
grille (the speaker grille is attached by “magic tape” and
can be easily pulled away from the speaker box). Lower
the speaker box (B) into place between the tops of the side
panels (E), center the speaker box to produce equal clear-
ance on the right and left sides, then attach each side (from
below) using two 6 x 18 millimeter flat head screws 4.
The grille side of the speaker box must be installed facing
the same direction as the pedals on the pedal box (C).
Make sure that the speaker cord rests in the appropriate
grooves and extends over the back of the speaker box, as
shown in illustration “a”.
CAUTION!: Be careful not to catch your fingers between
the speaker box and stand assembly when lowering the
speaker box into place!
N Install the main unit (A).
Rest the rear edge of the main unit (A) on the front
edges of the cutouts in the side panels (E), then slide the
main unit backward firmly until it stops (so that there is no
clearance between the main unit side panels and the stand,
as shown in the illustration “b”). WATCH YOUR FIN-
GERS WHILE DOING THIS!!
There is slight horizontal play between the main unit and
side panels, so center the main unit, as shown in the illus-
tration “c”, then attach the main unit with two 6 x 30
millimeter long black screws 5 in front and 6 x 18
millimeter two flat head screws 4 in back. After the
screws have been properly installed, re-attach the speaker
grille to the speaker box with the recessed corners facing
upwards (push it into place).
Speaker box installed.
Lautsprecherkasten in
Einbaulage
Haut-parleurs installés
Caja de los altavoces
instalada.
6 x 18 mm flat head screws 4
Senkschrauben (6 x 18 mm) 4
Vis à tête plate de 6 x 18 mm 4
Tornillos de cabeza plana de 6 x 18 mm 4
B
B
B
E
(a)
Speaker cord
Lautsprecherkabel
Cordon des haut-parleurs
Cable de los altavoces
B
Befestigen Sie den Lautsprecherkasten
(B) an den Seitenwänden (E).
Entfernen Sie vor dem Einpassen des
Lautsprecherkastens den Lautsprechergrill (der Grill wird
von Klettband gehalten und kann einfach abgezogen
werden). Setzen Sie den Lautsprecherkasten (B) danach
von oben her zwischen den Seitenwänden (E) auf die
beiden Winkelbleche, und richten Sie den Kasten dann
mittig zwischen den beiden Seitenwänden aus, bevor Sie
ihn mit jeweils einer Senkschraube (6 x 18 mm) 4 unten
an beiden Enden festschrauben. Die Seite mit den
Lautsprechern muß dabei in dieselbe Richtung weisen wie
die Pedale am Pedalkasten (C).
Achten Sie darauf, daß das Lautsprecherkabel in der
zugehörigen Nut liegt und hinten über den
Lautsprecherkasten hinaushängt, wie in Detailzeichnung
“a” gezeigt.
VORSICHT! Klemmen Sie beim Einpassen des
Lautsprecherkastens zwischen den beiden Seitenwänden
nicht Ihre Finger ein!
N Montieren Sie die Tastatureinheit (A).
Setzen Sie die Hinterkante der Tastatureinheit (A) auf
die ausgeschnittenen Ecken der beiden Seitenwände (E),
und schieben Sie die Tastatureinheit dann bis zum
Anschlag nach hinten (zwischen der Tastatureinheit und
den Seitenwänden darf an dem in Abbildung “b” gezeigten
Punkt kein Zwischenraum verbleiben). KLEMMEN SIE
IHRE FINGER DABEI NICHT EIN!!
Die Tastatureinheit hat zwischen den beiden
Seitenwänden etwas Spiel. Richten Sie die Tastatureinheit
gemäß Abbildung “c” mittig aus, und machen Sie sie dann
vorn mit zwei langen schwarzen Schrauben (6 x 30 mm)
5 und hinten mit zwei Senkschrauben (6 x 18 mm) 4
fest. Nach Montieren der Tastatureinheit bringen Sie dann
den Lautsprechergrill wieder mit den beiden
ausgeschnittenen Ecken nach oben am Lautsprecherkasten
an (der Grill wird einfach angesetzt und festgedrückt).
iii
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CLP-157 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CLP-157 in the language / languages: French as an attachment in your email.

The manual is 2,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CLP-157

Yamaha CLP-157 User Manual - English - 39 pages

Yamaha CLP-157 User Manual - German - 39 pages

Yamaha CLP-157 User Manual - Swedish - 31 pages

Yamaha CLP-157 User Manual - Spanish - 39 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info