590508
27
Zoom out
Zoom in
Previous page
1/37
Next page
4
4 x 25 mm round-head screws 3
Halbrundschrauben (4 x 25 mm) 3
Vis à tête ronde de 4 x 25 mm 3
Tornillos de cabeza redonda de 4 x 25 mm 3
CLP-155 CLP-154S
V
Attach the center panel (B) to the side
panels (D).
The center panel (B) should be screwed to the brackets
on the side panels (D) using the four 4 x 25 millimeter
round-head screws 3, as shown in the illustration. Make
sure the center panel is attached to the side of the brackets
facing the pedals. The corner cutouts in the CLP-155
center panel are on the top edge of the panel.
B Install the main unit (A).
Place the main unit (A) on the side panels (D) with the
screws on its bottom panel (toward the rear of the main
unit) just behind the grooves in the brackets located at the
top of the side panels. Then slide the main unit forward
until it stops. WATCH YOUR FINGERS WHEN DO-
ING THIS!!
Align the holes on the bottom panel of the main unit
with the holes in the brackets on the side panels (also
center the main unit to produce equal clearance on the left
and right sides, as shown in the illustration), then screw in
and securely tighten the four 6 x 16 millimeter flat-head
screws 4.
D
B
B
D
4 x 25 mm round-head screws 3
Halbrundschrauben (4 x 25 mm) 3
Vis à tête ronde de 4 x 25 mm 3
Tornillos de cabeza redonda de 4 x 25 mm 3
iii
V
Schrauben Sie die Rückwand (B) an die
beiden Seitenwände (D).
Die Rückwand (B) wird mit den vier Halbrundschrauben
(4 x 25 mm) 3 an den Winkelblechen der Seitenwände
(D) festgeschraubt, wie in der Abbildung gezeigt. Achten
Sie bitte darauf, daß die Rückwand an den pedalseitigen
Flächen der Winkelbleche angebracht wird. Beim CLP-155
müssen die Ausschnitte in den Ecken der Rückwand oben
zu liegen kommen.
B Montieren Sie die Tastatureinheit (A).
Setzen Sie die Tastatureinheit (A) so auf den fertigen
Ständer, daß die beiden Schrauben an ihrer Unterseite hin-
ter den Winkelblechen mit Führungsschlitz an der Hinter-
seite des Ständers zu liegen kommen. Schieben Sie die
Tastatureinheit dann bis zum Anschlag in die Schlitze.
KLEMMEN SIE IHRE FINGER DABEI NICHT EIN!!
Richten Sie die Schraubenbohrungen an der Unterseite
der Tastatureinheit mit den Bohrungen der Winkelbleche
aus (achten Sie auch darauf, daß sie mittig auf dem Ständer
steht, wie in der Abbildung gezeigt). Schrauben Sie die
Tastatureinheit dann mit den vier Senkschrauben (6 x 16
mm) 4 am Ständer fest.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CLP-155 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CLP-155 in the language / languages: French as an attachment in your email.

The manual is 2,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CLP-155

Yamaha CLP-155 User Manual - English - 35 pages

Yamaha CLP-155 User Manual - German - 37 pages

Yamaha CLP-155 User Manual - Swedish - 30 pages

Yamaha CLP-155 User Manual - Spanish - 37 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info