40
HOW TO USE THE BUILT-IN TIMER
Timer play
By using the built-in timer, you can set the time when the unit
turns on and a source begins playing automatically, and the
time when the unit turns off automatically.
1 Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For tape deck:
Load a tape into the cassette compartment.
(For KXW-S70, if tapes are loaded in both the
compartments, tape A takes priority of tape B, and is
played back by the timer play.)
For CD player:
Load a disc on the disc table. If more than one disc are
loaded on the disc table, select the disc by using the disc
select buttons or the DISC SKIP button.
2 Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the display
mode changes as follows.
At each mode, make a setting for the timer play, referring
to the setting procedure described below.
➀ Current time (TIMER on/off mode)
➁ Source selecting mode (TAPE, TUNER, CD)
➂ ON TIME/Time setting mode
➃ OFF TIME/Time setting mode
➄ Normal display mode
* The display mode will be changed to the next mode
after about 8 seconds elapse automatically. If the mode
is changed before the setting is completed, call the
mode again by pressing the DISPLAY button once or
more.
Setting procedure:
➀ At the display of current time
Check to be sure that the current time is correct, and
press the TIMER button so that “TIMER” appears on
the display.
➁ At source selecting mode
Select the source (TAPE, TUNER or CD) to be played
by pressing the corresponding input selector button.
* If “TUNER” is selected, soon it is changed to the
frequency display mode. In this mode, you can
select the station to listen to with the timer play by
using the BAND button, A/B/C/D/E button and
TUNER PRESET DOWN/UP buttons.
→
→→→ →
2 2-➀ 2-➁
Receiver