32
• When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
• The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
• Adjusting the VOLUME, BALANCE, TREBLE and BASS
controls have no effect on the recorded sound.
• For KXW-S70, the deck which can be used for recording
is the DECK B only. When recording, be sure to load a
tape into the DECK B cassette compartment.
CD synchronized recording
1 Press the CD input selector button and load the disc to be
recorded.
2 Load a tape into the cassette compartment.
* Wind past the beginning part of the tape on which
recording can not be performed.
3 When recording with the Dolby NR system, set the Dolby
NR switch to B or C; if not, set it to OFF.
* For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 28 or
30.
4 Set the reverse mode switch as desired.
When the tape is set so that side A faces you, recording will
be done as follows automatically according to the selected
reverse mode.
5 Press the REC/PAUSE button.
* The corresponding indicator will light up and the play
direction indicators flash.
6 Start CD playback by pressing the corresponding disc
select button, or by pressing the play/pause button if the
disc is already selected.
* Before CD playback begins, recording automatically
begins on the side of the tape now selected.
RECORDING COMPACT DISCS
