E-15
English
COMPACT DISC PLAYER OPERATION
DIGITAL SOUND FIELD PROCESSOR (DSP) CONTROL
Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the
disc surface.
Follow the guidelines below for maximum enjoyment from
your CD collection and player.
•
Do not write on either side of the disc, particularly the non-
label side. Signals are read from the non-label side. Do
not mark this surface.
•
Keep your discs away from direct sunlight, heat and
excessive moisture.
•
Always hold the CDs by the edges. Fingerprints, dirt or
water on the CDs can cause noise or mistracking. If a CD
is dirty or does not play properly, clean it with a soft, dry
cloth, wiping straight out from the center, along the radius.
Listening to the music with the
DSP
1 Press the DSP ON/OFF switch so that “ON DSP”
illuminates on the display.
2 Select a desired DSP mode by pressing the DSP MODE
selector button once or more until the name of the mode
appears on the display.
3 Playback a source. (For source playback, refer to other
sections described later.)
4 Adjust the level of effects by pressing the EFFECT LEVEL
down (–) or up (+) button.
* Effect level can be checked with the effect level indicator
on the display.
If you will not use the DSP
Press the DSP ON/OFF switch so that “DSP OFF”
illuminates on the display.
When listening with headphones
Press the SP/PHONES mode button so that the phones
mode indicator is illuminated on the display.
You can obtain a DSP effect suitadle for the headphone
listening.
If not using headphones, the SP/PHONES mode button
should be set so that the phones mode indicator is not
illuminated on the display.
Note
DSP effect is also recorded along with a source. If you wish
to record a source without DSP effect, turn the DSP off when
recording.
Receiver
