E-36
• When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
• The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
• Adjusting the VOLUME, BALANCE, TREBLE and BASS
controls have no effect on the recorded sound.
<Except U.K. and Europe models>
If, however, the DSS is on, DSS effect is recorded along
with the source.
* Music with DSS effect is suitable for listening to inside a
car etc.
• The deck which can be used for recording is the DECK B
only. When recording, be sure to load a tape into the
DECK B cassette compartment.
Recording from the built-in tuner
1 Select the TUNER position with the INPUT SELECTOR
control, watching the display.
2 Tune to the desired station. (Refer to the “TUNING
OPERATION” on pages 19 and 20.)
3 Load a tape into the DECK B cassette compartment.
4 When recording with the Dolby NR system, set the Dolby
NR switch to B or C; if not, set it to OFF.
* For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 29.
5 Set the reverse MODE switch to to record on only
one side, or to (or ) for
continuous recording on both sides.
6 Press the REC/PAUSE button.
* The corresponding indicator lights up and the play
direction indicators flash.
7 Press the play button to record on side A, or the play
button to record on side B.
* For continuous recording on both sides, begin on side
A. Recording stops automatically at the end of side B.
To stop recording temporarily
11 Press the REC/PAUSE button.
22 To resume recording, press the play button whose
indicator is flashing.
To stop recording
Press the stop button.
OTHER RECORDINGS
Receiver
3 5
7, 22 6, 11 7, 22
Tape Deck
4 3