E-28
Winding the tape
1 If during playback, first press the stop button.
2 Next press the fast wind or fast wind button to
wind the tape.
3 Press the stop button to stop.
* While winding the tape, the corresponding play direction
indicator flashes rapidly.
Note
When the tape is wound to the end, this unit will then function
as described below, according to the setting of the reverse
MODE switch.
: The tape stops at the end.
: If the winding direction is , when the tape reaches
the end, playback automatically starts from the reverse
side.
If the winding direction is , the tape stops at the
end.
: When the tape reaches the end, playback
automatically starts from the reverse side.
Searching for the beginning of a
desired selection
Carry out the following operation during playback to find the
beginning of a desired selection on the tape.
To listen to the same selection
Press the button if the direction of the current playback
is .
Press the button if the direction of the current playback
is .
To listen to the next selection
Press the button if the direction of the current playback
is .
Press the button if the direction of the current playback
is .
* While searching, the corresponding play direction indicator
flashes slowly.
Notes
•
This function may not work for tapes with
* Material with long pauses or quiet passages.
* Low recording levels or excessive noise.
* Pauses of less than 4 seconds between selections.
•
If searching is carried out at the first or the last part of a
selection, the desired selection may not be found.
TAPE DECK OPERATION
Tape Deck
