E-11
English
COMPACT DISC PLAYER OPERATION
Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the
disc surface.
Follow the guidelines below for maximum enjoyment from
your CD collection and player.
•
Do not write on either side of the disc, particularly the non-
label side. Signals are read from the non-label side. Do
not mark this surface.
•
Keep your discs away from direct sunlight, heat and
excessive moisture.
•
Always hold the CDs by the edges. Fingerprints, dirt or
water on the CDs can cause noise or mistracking. If a CD
is dirty or does not play properly, clean it with a soft, dry
cloth, wiping straight out from the center, along the radius.
Listening to the music with the
DSS
1 Press the DSS ON/OFF selector button so that the effect
level indicator lights up on the display.
2 Select a desired DSS mode by pressing the DSS MODE
selector button once or more until the name of the desired
mode appears on the display.
3 Playback a source. (For source playback, refer to other
sections described later.)
4 Adjust the level of effects by pressing the EFFECT LEVEL
down (–) or up (+) button.
* Effect level can be checked with the effect level indicator
on the display.
* Each of the DSS modes can be set with a different effect
level.
If you will not use the DSS
Press the DSS ON/OFF selector button so that the effect
level indicator on the display goes off.
When listening with headphones
Press the SP/PHONES mode selector button so that the
phones mode indicator lights up on the display.
You can obtain a DSS effect suitable for the headphone
listening.
If not using headphones, the SP/PHONES mode selector
button should be pressed so that the phones mode indicator
on the display goes off.
Note
DSS effect is also recorded along with a source. If you wish
to record a source without DSS effect, turn the DSS off when
recording.
