478492
14
Zoom out
Zoom in
Previous page
1/180
Next page
VX-8DR/DE OPERATING MANUAL12
INTERFACE OF PACKET TNCS
The VX-8DR/DE may be used for Packet operation, using the optional CT-M11 MIC/SP
Connection Cable (available from your Yaesu dealer) for easy interconnection to com-
monly-available connectors wired to your TNC.
The audio level from the receiver to the TNC may be adjusted by rotating the DIAL knob
while pressing and holding the key, as with voice operation. The input level to the
VX-8DR/DE from the TNC should be adjusted at the TNC side; the optimum input volt-
age is approximately 5 mV at 2000 Ohms.
Be sure to turn the transceiver and TNC off before connecting the cables, to prevent volt-
age spikes from damaging your transceiver.
CT-M11 MIC/SP Connection Cable
If you wish to disable the
VX-8DR/DE internal
speaker while packet
operation, connect a 22
k resistor between
wires Black and Gray.
TNC
SP
Brown
Red
Black
Gray
Orange
GND
GND
2 k
22 k
10 Fµ
MIC
PTT
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu VX-8DE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu VX-8DE in the language / languages: English as an attachment in your email.

The manual is 6,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info