674768
164
Zoom out
Zoom in
Previous page
1/173
Next page
164
Appendix
If you suspect malfunction Check the following items before requesting a repair.
The transceiver does not turn on.
Is the battery depleted?
Charge the battery pack after purchase, and when the transceiver has not been used for a long time.
Is the battery pack properly attached?
Refer to “Mounting the battery pack” and securely mount the battery pack.
Is the external power supply properly connected?
When using an external power supply, connect the external power supply adapter with a cigarette
lighter plug (SDD-13) or an external power cable (E-DC-6) to DC input jack.
Is the voltage of the battery pack or the SDD-13 correct?
Be sure that there is a charge left in the battery pack (do not completely discharge). Check that the
output voltage of the SDD-13 is approximately 12V.
There is no sound.
Is the level of squelch (or S meter squelch) set too high?
Press the Monitor Switch and verify that you can hear white noise.
Adjust the level of squelch (or S meter squelch) when receiving a weak signal.
Is the volume low?
Rotate the VOL knob clockwise to increase the volume.
Is the tone squelch or DCS on?
When the tone squelch or DCS is on, the sound is not output until the transceiver receives a signal
containing the same tone frequency or DCS code set.
There is no transmission of radio waves.
Are you pressing the switch properly?
Is the PTT lock on?
Is the Busy TX Block (BCLO function) on?
When the Busy TX Block (BCLO function) is on, transmission cannot be done when receiving a signal
even if
is pressed. Wait until signal being received stops and then press .
Is the transmission frequency on a ham radio band?
Transmission cannot be performed on the AM Radio Broadcast Band/ Short Wave Radio Band/ FM
Radio Broadcast Band/ Air Band/ Information Radio Band.
Is the voltage of the battery pack or external power source correct?
Check the remaining charge on the battery pack.
In addition, using an inadequate power supply where voltage drops during transmission will prevent
the FT2DR/DE from operating at full capability.
The keys or DIAL does not respond.
Is the Key Lock or DIAL Lock on?
164


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT2DR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT2DR in the language / languages: English as an attachment in your email.

The manual is 40,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info