674754
52
Zoom out
Zoom in
Previous page
1/156
Next page
Page 50 FT DX 9000D OPERATION MANUAL
Using Headphones for Dual Receive
To take advantage of dual reception, you will want to connect stereo headphones to the PHONES jack. Like the AF GAIN
control, headphone audio mixing can also be configured as desired from Menu Selection “RX AUDIO 076 HEADPHONE
MIX.” Three audio mixing schemes are selectable as follows:
OFF: Audio from the Main band (VFO-A) receiver is heard only in the left ear, and Sub band (VFO-B) receiver audio
solely in the right ear.
MID: Audio from both Main (VFO-A) and Sub (VFO-B) band receivers can be heard in both ears, but Sub band (VFO-
B) audio is attenuated in the left ear and Main band (VFO-A) audio is attenuated in the right ear.
FULL: Audio from both Main (VFO-A) and Sub (VFO-B) band receivers is combined and heard equally in both ears
“Monaural” mode).
Sideband Diversity Reception
Here you receive a single AM signal through the two receivers, each receiving the opposite sideband. Skywave-propagated
signals often show phase distortion in this mode, but it gives you a view of the entire passband, from which you can then
select the best sideband for listening (or for SWL Dx’ing, you may want to listen to both sidebands at the same time, to get
the best copy). On groundwave signals, where the phase of the sidebands is likely to be the same, there is an interesting
sense of depth to the signal.
To tune in a signal using this mode, you should have stereo headphones connected to the front panel PHONES jack or an
external stereo speaker connected to the rear panel EXT SP jacks.
DUAL RECEIVE: FULL DUPLEX OPERATION
Ì Set the main band (VFO-A) to either LSB or USB
mode, and tune for zero beat on the desired signal.
Ì Press the AB button (# ) to copy this mode and
frequency into the sub band (VFO-B), then press the
mode button to select the opposite sideband for the
main band (VFO-A).
Ì If using headphones, set the headphone mixing scheme
to the “COMBINE-1” mode via the Menu Selection
76: Head Phone Mix , and activate dual reception.
Ì Adjust the AF GAIN knob(s) to balance the vol-
ume of the two receivers.
If interference is present on one of the channels, you may
have to turn its AF GAIN control to suppress that channel
(or press the green “RX” LED/button to disable the re-
ceiver with the sideband experiencing interference). Oth-
erwise, try changing the headphone audio mixing scheme
to “FULL” or “OFF” in the Menu Selection “RX AUDIO
076 HEADPHONE MIX” for different effects (or try set-
tings with similar effects on your external amplifier). Al-
though you don’t get the “stereophonic” effect in the mon-
aural mode, the two signals are still mixed, offering the
potential for much better copy than in regular AM or even
single-sideband ECSS modes.
CONVENIENT FEATURES
switch
switch
Main (VFO-A)
switch
Sub (VFO-B)
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-DX9000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-DX9000 in the language / languages: English as an attachment in your email.

The manual is 25,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info