478504
18
Zoom out
Zoom in
Previous page
1/132
Next page
Page 16 FT-950 OPERATING MANUAL
[
POWER
]
Switch
Press and hold in this switch for two seconds to turn
the transceiver on. Similarly, press and hold in this
switch for two seconds to turn the transceiver off.
[
ANT 1-2
]
Switch
Pressing this switch selects the ANT 1 or the ANT 2
connector on the rear panel, and allows convenient an-
tenna switching at the press of button. The selected
antenna jack is indicated on the Block Diagram Dis-
play shown in the Transceiver Display.
[
TUNE
]
Switch
This is the on/off switch for the FT-950s Automatic
Antenna Tuner.
Pressing this button momentarily places the antenna
tuner in line between the transmitter final amplifier and
the antenna jack (The “ ” icon will appear in
the display). Reception is not affected.
Pressing and holding in this button for two seconds,
while receiving in an amateur band, activates the trans-
mitter for a few seconds while the automatic antenna
tuner rematches the antenna system impedance for
minimum SWR. The resulting setting is automatically
stored in one of the antenna tuners 100 memories, for
instant automatic recall later when the receiver is tuned
near the same frequency.
Pressing this button momentarily, while the Tuner is
engaged, will take the Automatic Antenna tuner out of
the transmit line.
NOTE:
When the Automatic Antenna Tuner is tuning itself, a
signal is being transmitted. Therefore, be certain that
an antenna or dummy load is connected to the selected
antenna jack before pressing and holding in the
[
TUNE
]
button to start antenna tuning.
FRONT PANEL CONTROLS & SWITCHES
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-950 in the language / languages: English as an attachment in your email.

The manual is 6,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info