478504
12
Zoom out
Zoom in
Previous page
1/132
Next page
Page 10 FT-950 OPERATING MANUAL
TO
1
ANT
DC I N
2
FROM
GND
ROT LINEAR TUNER
PTT REC REM KEY
DMU CAT
EXT
SPKR
-TUNE
-TUNE
INPUT
22 A
: DC 13.8 V
A
N
T
E
N
N
A
2
A
N
T
E
N
N
A
1
VA
005510 2015 3020 40
CONTINUOUS CURRENT 25A
OVERLOAD
POWER
ON
OFF
RED BLACK
FUSE: 25A
CONNECTION OF ANTENNA AND POWER CABLES
Please follow the outline in the illustration regarding the proper connection of antenna coaxial cables, as well as the DC
power cable. The DC power connector for the FT-950 must only be connected to a DC source providing 13.8 Volts DC
(±10 %), and capable of at least 22 Amperes of current. Always observe proper polarity when making DC connection:
The RED DC power lead connects to the Positive (+) DC terminal.
The BLACK DC power lead connects to the Negative (–) DC terminal.
We recommend the use of the FP-1030A AC Power Supply. Other models of power supplies may be used with the FT-950,
but the 13.8 VDC input voltage, 22-Ampere current capability, and DC cable polarity guidelines described above must be
strictly followed.
Note that other manufacturers may use the same type of DC power connections as does your FT-950 transceiver, however,
the wiring configuration may be different from that specified for your transceiver. Serious damage can be caused if im-
proper DC connections are made; consult with a qualified service technician when in doubt.
Permanent damage can result when improper supply voltage, or reverse-polarity voltage, is applied to the FT-950.
The Limited Warranty on this transceiver does not cover damage caused by application of AC voltage, reverse
polarity DC, or DC voltage outside the specified range of 13.8 V ±10 %. When replacing fuses, be certain to use a fuse of
the proper rating. The FT-950 requires a 25 A blade fuse.
ADVICE:
Do not position the FT-950 in a location with direct exposure to sunshine.
Do not position the FT-950 in a location exposed to dust and/or high humidity.
Ensure adequate ventilation around the FT-950, to prevent heat build-up and possible reduction of performance due to
high heat.
Do not install the FT-950 on an unstable desk or table. Do not place in a location where objects may fall onto it from above.
To minimize the possibility of interference to home entertainment devices, take all precautionary steps including sepa-
ration of TV/FM antennas from Amateur transmitting antennas to the greatest extent possible, and keep transmitting
coaxial cables separated from cables connected to home entertainment devices.
Ensure that the DC power cord is not subject to undue stress or bending, which could damage the cable or cause it to be
accidentally unplugged from the rear panel DC IN jack.
Be certain to install your transmitting antenna(s) so they cannot possibly come in contact with TV/FM radio or other
antennas, or with power or telephone lines.
INSTALLATION AND INTERCONNECTIONS
To prevent the damage from a
thunder, atmospheric electric-
ity, electrical shock etc., please take a
good earth ground.
Use a short, thick,
braided cable to
connect your sta-
tion equipment to
the buried ground
rod (or alternative earth ground system).
Check a DC voltage and
current rating (+13.8 V,
22 A) of the power supply before
connecting to the transceiver.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-950 in the language / languages: English as an attachment in your email.

The manual is 6,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info