478500
73
Zoom out
Zoom in
Previous page
1/76
Next page
Page 71FT-897D OPERATING MANUAL
APPENDIX
MH-59A8J REMOTE MICROPHONE
[
F
(
D
)]
key
Press this key momentarily to enable the changing of
the function of the Multi Function keys (
[
A
]
,
[
B
]
,
and
[
C
]
) by the MEM/VFO CH knob.
Press and hold in this key for one second to activate
the “Menu” mode.
This key generates the DTMF “D” tone during trans-
mission, and frequency entry digit “point” during
Direct Keypad Frequency Entry.
[
ACC
]
key
Press this key to disable the Noise Squelch.
You may program the configuration of this key, to
enable use of a different function, via Menu Mode
No-068
[
PG ACC
]
.
[
PWR
(
FAST
)]
key
Press and hold in this key for one second to turn the
transceiver on or off.
While the transceiver is turned on, pressing this key
momentarily will engage the “Fast Tuning” mode, to
allow more rapid frequency navigation (a small “run-
ning man” icon will be observed in the bottom right-
hand corner of the LCD).
[
P1
]
key (Quick Split)
Press this key to change the Sub VFO frequency
(Main VFO frequency + 5 kHz) and automatically
engage the ”Split” feature.
You may program the configuration of this key, to
enable use of a different function, via Menu Mode
No-069
[
PG P1
]
.
[
P2
]
key
Press this key to engage the 1750-Hz burst tone for
access of a repeater requiring tone burst (typically in
Europe).
You may program the configuration of this key, to
enable use of a different function, via Menu Mode
No-070
[
PG P2
]
.
P
1
7
1
4
8
2
0
5
9
B
A
C
D
3
6
A
C
C
P
2
DTMF MICROPHONE
MH-59
SEL Knob
This rotary switch is used for VFO frequency tuning,
memory channel selection, and receiver audio volume
level adjustment.
SEL/DIAL Key and Indicator
The SEL key switches the synthesizer steps of the SEL
knob between the fine tuning (same as DIAL knob step)
and coarse tuning (same as SEL knob step) modes.
When the “fine tuning” mode is selected, the SEL LED
glows orange.
Press and hold in this key for one second to enable the
“VOL” feature, which allows adjustment of the receiver
audio volume level (by adjusting the SEL knob). When
the “VOL” feature is engaged, the SEL LED glows
green.
To return to the synthesizer step-selection mode, just
press the SEL key.
[
UP
]
/
[
DWN
]
Keys
Press (or hold in) either of these keys to tune (or scan
up or down) the operating frequency or through the
memory channels. In many ways, these keys emulate
the function of the FT-897D’s DIAL knob.
73


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-897D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-897D in the language / languages: English as an attachment in your email.

The manual is 3,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info