478500
13
Zoom out
Zoom in
Previous page
1/76
Next page
Page 11FT-897D OPERATING MANUAL
CW KEY/KEYER CONNECTIONS
All commonly-available keyer paddles should work perfectly
with the built-in Electronic Keyer. The wiring configuration
for the paddle is shown below.
For straight-key operation, only the tip and shaft connec-
tions are used.
RECEIVER ACCESSORIES
(
T
APE RECORDER ETC.
)
Connection of a tape recorder or other such receiver acces-
sory is easily accomplished by using the DATA jack’s Data
Out (1200 bps) terminal (Pin 5) and Ground (Pin 2). The
audio output is fixed at 100 mV, with an impedance of 600
.
INSTALLATION
Note: Even when using a straight key, you must use a three-
conductor (“stereo”) plug. If a two-conductor plug
is used, the key line will be constantly shorted to
ground.
When using an external electronic keyer, be absolutely cer-
tain that it is configured for “positive” keying, not “nega-
tive” or “grid block” keying. The “key-up” voltage of the
FT-897D is +5V, and the “key-down” current is only about
1 mA.
For CW automated keying using a personal computer, with
an external memory keyer providing for manual sending, it
usually is possible to connect the keyed lines together via a
“Y” connector. Check with the documentation accompany-
ing your keyer and your contest/DX software for any cau-
tions which need to be observed.
KEY
GND
GNDKEY
COMMON
COMMON
DOT
DOT
DASH
DASH
ADJUSTING THE FRONT BAIL
The front bail of the transceiver allows the transceiver to be
tilted upward for better viewing. Simply fold bail forward
to raise the front of the transceiver, and fold bail back against
the bottom case to lower the front of the FT-897D.
DATA
DATA OUT
1200bps
GND
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-897D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-897D in the language / languages: English as an attachment in your email.

The manual is 3,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info