36023
44
Zoom out
Zoom in
Previous page
1/76
Next page
Page 42 FT-897D OPERATING MANUAL
ATAS-100/-120 Operating Tips
The information below will help you derive the best perfor-
mance possible from the ATAS-100/-120 Active-Tuning An-
tenna System.
Grounding
It is critically important that you establish a good mechani-
cal and RF ground connection for your ATAS-100/-120 (as
with all vertical antennas). Mobile mounts which are bolted
through the vehicle’s roof, or otherwise mechanically af-
fixed, will usually be satisfactory. However, magnetic mounts
do not provide the RF grounding necessary for good perfor-
mance, and are not recommended for use with this antenna.
Tuning Procedure
The feedpoint impedance of the ATAS-100/-120 (resistance
and reactance) will necessarily vary over a wide range when
you change bands. Occasionally, the transceiver’s micro-
processor will not initially be able to determine the proper
direction for the ATAS-100/-120 to travel (inward or out-
ward) for best SWR.
To resolve this situation, the transceiver will then command
the ATAS-100/-120 to retract fully to its minimum height,
and thence restart the tuning process. In this instance, the
TUNE” icon will remain on the display after you press the
[
A
](
TUNE
)
key. If this happens, do not press the
[
A
](
TUNE
)
key repeatedly. The transceiver will remain in the receive
mode as it retracts (this may take up to one minute). There-
after, the transmitter will be engaged, and the ATAS-100/-
120 will be automatically adjusted for best SWR. The
TUNE” icon will then disappear from the LCD, and you
will be ready for operation.
TRANSMITTER OPERATION
External Wattmeters
If you wish to use an external wattmeter in conjunction with
the transceiver and your ATAS-100/-120, please check the
wattmeter with an Ohmmeter prior to installation. Be sure
there is a direct connection between the “In” and “Out” jacks
of the wattmeter (zero resistance), and also ensure that there
is a completely open circuit between the center pin and shield
of the wattmeters output jack. Some wattmeters use a coil
or other device which shorts the center pin to ground at DC,
and this type of internal wattmeter circuitry will not allow
the tuning function of the ATAS-100/-120 to operate.
Operation on 30/17/12 Meters
Although the ATAS-100/-120 is not specified for opera-
tion on the above bands, and optimum operation is there-
fore not guaranteed, the ATAS-100/-120 generally can be
tuned successfully on these bands (some manual adjustment
may be required). Operation of the ATAS-100/-120 on these
bands will not damage the antenna’s components; please feel
free to experiment on these bands, if you like.
ACTIVE-TUNING ANTENNA SYSTEM
(
ATAS-100/-120
)
OPERATION
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu ft-897D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu ft-897D in the language / languages: English as an attachment in your email.

The manual is 3,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info