478499
19
Zoom out
Zoom in
Previous page
1/132
Next page
17FT-857D Operating Manual
The “TX GND” T/R control line is a transistor “open collector” circuit, capable of handling
positive amplifier relay coil voltages of up to +50V DC and current of up to 400 mA. If you
plan on using multiple linear amplifiers for different bands, you must provide external
band-switching of the “TX GND” relay control line from the CAT/LINEAR jack.
Important Note!
Do not exceed the maximum voltage or current ratings for the “TX GND” line at the
CAT/LINEAR jack. This line is not compatible with negative DC voltages, nor AC
voltages of any magnitude.
Most amplifier control relay systems require only low DC voltage/current switching
capability (typically, +12V DC at 25 ~ 75 mA), and the switching transistor in the
FT-857D will easily accommodate such amplifiers.
CW KEY/KEYER CONNECTIONS
All commonly-available keyer paddles should work perfectly with the built-in Electronic
Keyer. The wiring configuration for the paddle is shown below.
INSTALLATION
LINEAR AMPLIFIER INTERFACING
For straight-key operation, only the tip and shaft connections are used.
Note: Even when using a straight key, you must use a three-conductor (“stereo”) plug. If a
two-conductor plug is used, the key line will be constantly shorted to ground.
When using an external electronic keyer, be absolutely certain that it is configured for
“positive” keying, not “negative” or “grid block” keying. The “key-up” voltage of the FT-
857D is +5V, and the “key-down” current is only about 1 mA.
For CW automated keying using a personal computer, with an external memory keyer pro-
viding for manual sending, it usually is possible to connect the keyed lines together via a
“Y” connector. Check with the documentation accompanying your keyer and your contest/
DX software for any cautions which need to be observed.
COMMON
COMMON
DOT
DOT
DASH
DASH
KEY
GND
GNDKEY
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-857D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-857D in the language / languages: English as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info