444588
10
Zoom out
Zoom in
Previous page
1/104
Next page
Page 8 FT-450 OPERATION MANUAL
R
EAR
P
ANEL
J
ACKS
INPUT
DC 13.8V
22A
ANT
GND
EXT
SPKR
CATLINEARTUNERDATA
DC IN Jack
This is the DC power supply
connection for the transceiver.
Use the supplied DC cable to
connect directly to the car bat-
tery or to a DC power supply,
which must be capable of sup-
plying at least 22 A @13.8
VDC.
ANT Jack
Connect your antenna here, using a type-M (PL-259) co-
axial connector and 50 Ohm coaxial feedline.
Warning!: High Power RF voltage is present at the TX RF
section of the transceiver while transmitting. Absolutely!
Do not touch the TX RF section while transmitting.
DATA Jack
This 6-pin input/output jack provides receiver audio and squelch sig-
nals, and accepts transmit (AFSK) audio and PTT control, from an
external packet TNC.
LINEAR Jack
This 10-pin output jack pro-
vides band selection data,
which may be used for control
of the optional VL-1000 Solid-
State Linear Amplifier.
CAT Jack
This 9-pin serial DB-9 jack allows ex-
ternal computer control of the FT-
450. Connect a (straight) serial cable
here and to the RS-232C COM port
on your personal computer (no ex-
ternal interface is required).
EXT SPKR Jack
This 3.5-mm, 2-pin jack provides variable audio output for an external
speaker. The audio output impedance at this jack is 4 - 16 Ohms and
the level varies according to the setting of the front panel’s
[
AF GAIN
]
knob. Inserting a plug into this jack disables the internal loudspeaker.
GND Terminal
For safety and optimum performance, use this termi-
nal to connect the transceiver to a good earth ground.
Use a large diameter, short braided cable for making
ground connections. Refer to page 12 for other notes
about proper grounding.
SQL OUT
FSK IN
GNDDATA IN
DATA PTT
DATA OUT
TXD
TX GND OUT+13.8V OUT
GND
TUNER SENSE
TX INH IN
RXD
RESET OUT
BAND DATA-A (LSB)
TX GND OUT
+13.8V OUT
TXREG IN
GND
BAND DATA-B
BAND DATA-C
BAND DATA-D (MSB)
TX INH IN
EXT ALC IN
CTS RTS
GND
SERIAL IN
SERIAL OUT
Connect to
Connect to
N/A
Connect to
TUNER Jack
This 8-pin jack is used for Connection to
the FC-30 or FC-40 External Automatic
Antenna Tuner.
COOLING FAN
Turns at low speed in receive mode.
Turns at high speed when the temperature begins to
rise or in transmit mode.
(viewed from rear panel)
(viewed from rear panel)
(viewed from rear panel)
(viewed from rear panel)
(viewed from rear panel)
+
-
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-450 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-450 in the language / languages: English as an attachment in your email.

The manual is 9,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info