674792
42
Zoom out
Zoom in
Previous page
1/68
Next page
FT-252 OperaTing Manual40
The Smart Search feature allows you to load frequencies automatically according to
where activity is encountered by your radio. When Smart Search is engaged, the trans-
ceiver will search above and below your current frequency, storing active frequencies as
it goes (without stopping on them even momentarily); these frequencies are stored into
a special Smart Search memory bank, consisting of 31 memories (15 above the current
frequency, 15 below the current frequency, plus the current frequency itself).
Two basic operating modes for Smart Search are available:
SINGLE
: In this mode, the transceiver will sweep the current band once in each direc-
tion starting on the current frequency. All channels where activity is present
will be loaded into the Smart Search memories; whether or not all 31 memo-
ries are lled, the search will stop after one sweep in each direction.
CONT
: In this mode, the transceiver will make one pass in each direction as with One-
Shot searching; if all 31 channels are not lled after the rst sweep, however,
the radio will continue sweeping until they are all lled.
Setting the Smart Search Mode
1. Press the
[
SET/ATS
]
key to enter the Set mode.
2. Rotate the
DIAL
knob or press the
[
p
]
/
[
q
]
key to select
Set Mode Item 35:
S SRCH
.
3. Press the
[
SET/ATS
]
key momentarily to enable adjust-
ment of this Set Mode Item.
4. Rotate the
DIAL
knob or press the
[
p
]
/
[
q
]
key to select
the desired Smart Search mode (see above).
5. When you have made your selection, press the
PTT
switch to save the setting and exit to normal operation.
Storing Smart Search Memories
1. Set the radio to the VFO mode. Be sure that you have the Squelch adjusted properly (so
that band noise is quieted).
2. Press the
[
F/MW
]
key, then press the
[
LOW
]
key to begin the Smart Search scan-
ning.
3. As active channels are detected, you will observe the number of “loaded” channels
increasing in the regular memory channel window.
4. Depending on the mode you set for Smart Search opera-
tion (“
SINGLE
or
CONT
”), the Smart Search scan will
eventually terminate, and the LCD will revert to Smart
Search Memory Channel “
C
.”
5. To recall the Smart Search memories, rotate the
DIAL
knob to choose from among
the frequencies stored by Smart Search.
6. To return to normal operation, press the
[
VFO
(
PRI
)]
key.
Smart Search Operation
honbun_130313.indd 40 2013/03/13 19:48:03
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-252 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-252 in the language / languages: English as an attachment in your email.

The manual is 5,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info