Tango X2 User’s Guide | 7
Listening to the radio
1. Press the control wheel on the front of the unit until either
AM or FM frequency is displayed depending on your choice
(FM frequencies have a decimal point before the last number).
The display will turn off after 10 seconds.
2. Use the tuning controls on the top of the unit or on the
remote to tune to the desired frequency. Holding down the
tuning controls will scroll quickly through the frequencies.
3. Turn the control wheel on the front of the unit or use the
volume controls on the remote to adjust the volume to the
desired level.
Note: To ensure quality radio reception, Tango X2 will not charge
a docked iPod while FM or AM radio is selected as the source.
Setting the radio presets
1. Tune to the desired AM or FM frequency. You can set 3 presets
AM frequencies and 3 presets for FM frequencies.
2. Press and hold one of the three buttons on the top of the unit
until the display flashes with the desired frequency. This
preset is now set for the current frequency.
3. Repeat process to program remaining presets.
Listening to an auxiliary source
1. Connect the device to the “Line-in” jack on the back of the
unit with an auxiliary 3.5mm cable (cable not included).
2. Press the control wheel on the front of the unit until the
display shows “Aux” as the source. The display will turn off
after 10 seconds.
3. Press play on the device.
4. Turn the control wheel on the front of the unit or use the
volume controls on the remote to adjust the volume to the
desired level.
Note: To control functions other than volume on a device
connected through the line-in, you must control through the
device itself
.
