Manual Xterra TR3.0 TREADMILL (page 21 of 28) (English)

587178

Zoom out

Zoom in

1/28

TR3.0 Treadmill

Tread-belt Tension Adjustment - Belt tension is not critical for most users. It is very important

though for joggers and runners in order to provide a smooth, steady running surface. Adjust-

ment must be made from the rear roller with the 6mm Allen wrench provided in the parts

package. The adjustment bolts are located at the end of the step rails as shown in the dia-

gram below.

Tighten the rear roller only enough to prevent

slippage at the front roller. Turn the tread-belt

tension adjusting bolts 1/4 turn each and inspect

for proper tension by walking on the belt and

making sure it is not slipping or hesitating with

each step. When an adjustment is made to the

belt tension, you must be sure to turn the bolts on

both sides evenly or the belt could start tracking to

one side instead of running in the middle of the deck.

DO NOT OVERTIGHTEN – Over tightening will cause belt damage and premature bearing

failure. If you tighten the belt a lot and it still slips, the problem could actually be the drive belt

- located under the motor cover - that connects the motor to the front roller. If that belt is loose

it feels similar to the walking belt being loose. Tightening the motor belt should be done by a

trained service person.

Belt and Deck - Your treadmill uses a very high-efcient low-friction deck. Performance is

maximized when the deck is kept as clean as possible. Use a soft, damp cloth or paper towel

to wipe the edge of the belt and the area between the belt edge and frame. Also reach as

far as practical directly under the belt edge. This should be done once every other month to

extend belt and deck life. Use water only - no cleaners or abrasives. A mild soap and water

solution along with a nylon scrub brush will clean the top of the textured belt. Allow the belt

to dry before using.

Belt Dust - This occurs during normal break-in or until the belt stabilizes. Wiping excess off

with a damp cloth will minimize buildup.

General Cleaning - Dirt, dust, and pet hair can block air inlets and accumulate on the running

belt. On a monthly basis: vacuum underneath your treadmill to prevent buildup. Every other

month, you should remove the black motor hood and carefully vacuum out dirt that may

accumulate. UNPLUG POWER CORD BEFORE THIS TASK.

There is a maintenance schedule/chart included under the Table of Contents for convenient

record keeping.

Belt Adjustments

General Maintenance

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Xterra TR3.0 TREADMILL in the language / languages: English as an attachment in your email.

The manual is 1,82 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Xterra TR3.0 TREADMILL Manual

Product: