Xterra SB540r Bike
Maintenance:
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a thump, clicking or wobbly feeling develops the main cause is usually the pedals and/or
crank arms being loose.
Maintenance Menu in console software:
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance menu (may be called Engineering mode,
depending on version) press and hold down the Start, Stop and Enter keys. Keep holding the keys
down for about 5 seconds and the message window will display Engineering mode. Press the
enter button to access the menu below. Press the up and down keys to navigate the menu.
a. Display test (tests all the display functions, press enter to perform test)
b. Key test (will allow you to test all the keys to make sure they are functioning)
c. Functions (Press enter to access settings, use up/dn keys to scroll)
i. ODOMETER reset (reset the odometer)
ii. Units (Set to English or Metric display readings)
iii. Bike or Elliptical (changes settings so the console can be used on an
Xterra bike or elliptical)
iv. Sleep mode Turns on/off sleep mode.
v. Motor test (continually runs the tensioning gear motor)
vi. Manual (Allows stepping of the gear motor)
vii. Key tone (Turn on or off the beep when a key is pressed)
d. Security (Allows you to lock the keypad so no unauthorized use is allowed) When
the child lock is enabled, the console will not allow the keypad to operate unless
you press and hold the Start and Enter buttons for 3 seconds to unlock the
console.
e. Clear EEPROM for engineering use only