606331

Xterra MB880 INDOOR CYCLE Manual

12
Zoom out
Zoom in
Previous page
1/21
Next page
MB880 Indoor Cycle
9
XTERRA Fitness Indoor Cycling Console Battery Installation:
1. Remove the battery cover from the back of the computer.
2. Insert 2 AAA batteries into the battery compartment and reinstall the battery cover.
3. When Battery working voltage is too low, The “Low battery” indicator will show up on
the console display indicating it is time to change the batteries.
Speed Sensor Transmitter Battery Installation
1. Remove the battery cover from the transmitter.
2. Install 2 AAA batteries in the battery compartment and reinstall the battery cover.
3. When new batteries are installed in the transmitter or console you must perform the
synchronizing procedure below for the console to work properly
Synchronizing the transmitter to the console:
After installing the batteries, and before attaching the console and transmitter to the bike,
you must synchronize the two so they can ‘talk’ to each other.
1. Press and hold the two keys on the front of the console for about 3 seconds until the
display shows ID - -
2. Now press and hold the blue button on the transmitter for 3 seconds and release. The
console display should show ID 0. NOTE: You must press the blue button within 10
seconds after the console is showing ID - - otherwise the console will show: ID ER. If
the console shows this error then restart the procedure again.
3. It may be necessary to remove and re-install the batteries in both the
console and transmitter if you continue to receive an error.
Console Installation:
1. Install the mounting clamp (2) to the back of the console (1) with the clamp mounting
screw (3).
2. Install and slightly tighten the thumb screw (4) then adjust the console angle for
optimal visibility. Once the console is adjusted, continue to tighten the screw until it is
securely
attached to the handle bar.
Transmitter Installation:
• Make sure to route the speed sensor wire behind the frame member. Plug the sensor
wire into the transmitter as shown below
• Install the transmitter, at the angle shown below, onto the pre-installed Velcro strip
located on the back of the chain cover. Make sure the sensor wire connection is at
the top left when mounting the transmitter.
• Make sure the sensor wire is routed away from the spinning ywheel
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xterra MB880 INDOOR CYCLE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xterra MB880 INDOOR CYCLE in the language / languages: English as an attachment in your email.

The manual is 3,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info