Copy WorkCentre
®
5945/5955
84 User Guide
Use the Uncollated option if no finishing is required for the output.
Use the collation options to sort your copies into sets (1,2,3 1,2,3 1,2,3) or stacks (1,1,1 2,2,2
3,3,3).
Use the stapling options to staple your document. The options available are dependent on the
finishing device installed. The basic stapling options are Off, 1 Staple, 2 Staples and Multi-Staple.
Use the Hole Punched / Stapled option if you want your output to be hole punched or hole punched
and stapled. Each sheet will be punched individually so there is no limit to the number of pages you
can have in a set. Hole punching can only be selected for A4 LEF (8.5 x 11" LEF) and A3 (11 x 17”)
paper.
Note: The Collation options must be set before selecting the Hole Punched / Stapled options.
Note: SEF is Short Edge Feed (where the short edge of the paper is the leading edge when the paper
is fed into the device). LEF is Long Edge Feed (where the paper is oriented so that the long edge is
fed into the device first).
Use the Booklet options to automatically produce folded and stapled booklets. A cover can be
inserted onto the booklet automatically.
Use the Booklet Creation option to automatically reduce and arrange the images in the correct
sequence on your selected media, so that a booklet is created when the copy set is folded in half.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen.
5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.
6. If required, select the More... button at the bottom of the Copy Output section to access all the
finishing options. The number of options displayed will depend upon the finishing device and
kits installed (there may not be enough to require a More... button).
7. Select the Copy Output option required.
• Uncollated sorts your copies into stacks 1,1,1 2,2,2 3,3,3.
• Collated sorts your copies into sets 1,2,3 1,2,3 1,2,3.
•Stapled
• Hole Punched / Stapled
• Booklet
8. Select the OK button.
9. Enter the number of prints required using the numeric keypad on the control panel.
10. Press the Start button on the control panel to scan the original.
11. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
12. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
