684578

Xenteq LBC 512-15S Manual

20
Zoom out
Zoom in
Previous page
1/58
Next page
20
E N
Whether or not to run temperature compensation is determined in set-up mode.
If the T-sensor is present when in set-up mode, then temperature compensation
is automatically activated. If the charger does not detect the temperature
sensor during set-up mode, then the charging program will run normally.
Activating the sensor
Attach the temperature sensor to the designated connector at the front of the
charger. Next, set the charger to set-up mode (see chapter Setting the charger.
This can be done at the same time as choosing the charge setting). The orange
LED light for 'charge process' will illuminate, indicating that the charger has
detected the presence of the temperature sensor and will apply temperature
compensation to the charging voltage. The presence of the temperature sensor
is saved in the charger's memory.
If you don’t want to use the T-sense any longer, then you need to remove the
temperature sensor and run the charger set-up mode again. The charger will
not detect a sensor (orange LED remains switched off), which means that
charging will not be temperature compensated.
Temperature sensor protection
If the charger is set for the T-Sense1, but during use the charger fails to detect
the sensor, then the charger will stop charging and the red ‘power’ LED will
illuminate.
If the temperature sensor has not been activated, but while in use the charger
detects the temperature sensor, then the charging process will stop and the red
‘power’ LED will illuminate. In the event of any other errors, such as incorrect
measurements, etc., the charging process will stop and the red ‘power’ LED will
illuminate.
If the fault is settled, the charger must be reset (by means of the main power or
stand by function)
INSTALLATION
The atmosphere
The battery should be charged in an area with adequate ventilation because it
may emit explosive gases. Be sure that there is enough space around the
charger. This is important for the air circulation, for cooling of the charger and
release of gases emitted. The LBC 500S may not be used outdoors.
Important
Don’t not charge when there is a fuel leak or fuel is evaporating.
Mounting
The charger can be mounted in different ways (preferably vertically) with the
mounting plate on the bottem of the charger. Place the charger on a stabile
underground.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xenteq LBC 512-15S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xenteq LBC 512-15S in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info