673279
10
Zoom out
Zoom in
Previous page
1/40
Next page
Belt sander EN
1110
Then install onto the small pulley by rotating
clockwise and pushing the drive belt shown
around the small pulley at the same time. The
drive belt will be a tight fit. Fit the belt cover
and two screws.
WORKING HINTS FOR YOUR
BELT SANDER
If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run with no load for 2-3
minutes to cool the motor. Avoid prolonged
usage at very low speed. Always use a
sanding belt suited to the material you wish
to sand. Always ensure the work-piece is
firmly held or clamped to prevent movement.
Support large panels close to the sanding
area. Any movement of the material may
affect the quality of the sanding finish. Start
your sander before sanding and turn off only
after stopping sanding. For best results sand
wood in the direction of the grain. Do not start
sanding without the sanding belt fitted. Empty
the dust bag every 5 minutes or sooner to
ensure efficient dust collection.
MAINTAINANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a
dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal. If the supply
cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worx WX661.1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worx WX661.1 in the language / languages: English as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info