673303
18
Zoom out
Zoom in
Previous page
1/24
Next page
18
Troubleshooting
Symptom Possible Causes Possible Solution
Tool will not start
when operating the
on/off switch.
Power cord not
plugged in.
Power cord is
broken.
Carbon brush has
worn down
Check to make sure
power cord is connected
well into a working outlet.
Unplug the power
cord. Replace it using a
qualified maintenance
person.
Replace the carbon
brush using a qualified
maintenance person.
Cutting depth is less
than that is set.
Sawdust
accumulated at
the rear of the
base.
Shake out sawdust.
Consider connecting
a vacuum for dust
collection.
Blade spins or slips
Blade is not tightly
engaged with the
spindle.
Remove the blade,
and reassembled it as
described in INSTALL /
CHANGE THE BLADE
section.
Blade will not cut a
straight line.
Blade is dull.
Blade is not
mounted properly.
Saw is not being
guided properly.
Mount a new, sharp
blade on the saw.
Check that blade is
properly mounted.
Use an edge guide.
Blade kicks back
when beginning a cut
Blade is not
spinning fast
enough
Allow the saw blade to
reach full speed prior to
beginning a cut
Environmental protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worx WU420 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worx WU420 in the language / languages: English as an attachment in your email.

The manual is 6,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info