673303
11
Zoom out
Zoom in
Previous page
1/24
Next page
11
3) Clean the replacement saw blade and all the clamping parts to be
assembled. Slide the saw blade up through the slot and fit it onto
the inner spindle. Assemble the blade clamping washer (18) and the
spindle clamping screw (17). Use the two spanners to tighten the
spindle clamping screw thoroughly.(See Fig. C)
The steps involved in changing the blade are the same as the steps
used when installing the blade.
NOTE: Remove both spanners after the saw blade is tightly
attached.
WARNING: When mounting, ensure that the cutting direction of
theeth (direction of arrow on saw blade) and the direction-of-rotation
arrow above the blade guard match.
NOTE: Never use a blade that is too thick to allow the blade clamping
washer to engage with the flat side of the spindle.
The table below gives you advice on how to choose correct
blade.
Blade type Cutting material
TCT 24T Wood and aluminum
HSS 44T Thin sheet steel and aluminum, PVC pipe, plastic .
Diamond Concrete, marble, tile , cement backerboard.
Recommended maximum material thickness
Wood 27 mm
Aluminum 3 mm
PVC pipe (radius) 13 mm
Tile 8 mm
Sheet steel 0.91mm ( 20gauge)
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worx WU420 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worx WU420 in the language / languages: English as an attachment in your email.

The manual is 6,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info