576048

Worx WG594E.3 Manual

12
Zoom out
Zoom in
Previous page
1/116
Next page
Cordless Li-Ion Blower/Sweeper EN
12
ASSEMBLY
ASSEMBLING THE BLOWER TUBE
(See Fig. A & Fig. B)
Before assembling the Blower Tube (4), be
sure the on/off switch (2) is in ‘’O’’ Off position.
Fit the Blower Tube to the motor housing as
shown in Fig. A. Fix the blower tube to the
blower port with the screw provided. Check
the Blower Tube is firmly secured.
WARNING! Do not attempt to
operate or disable the On/Off
Switch by any means other than the
normal assembly or removal of the tube.
NOTE: Before disassembling the Blower
Tube, be sure the on/off switch (2) is in ‘’O’’ Off
position. Loosen the screw. Press the Release
Button (3), so that you can separate the tube
(See Fig. B). Do not try to separate the tubes
by force or by using tools.
OPERATION
INTENDED USE:
The blower is intended for blow debris.
It’s not intended for use indoors and animal
grooming.
WARNING! The charger and battery
pack are specially designed to
work together so do not attempt to use
any other devices. Never insert or allow
metallic objects into your charger or
battery pack connections because of an
electrical failure and hazard will occur.
1. BEFORE USING YOUR CORDLESS
BLOWER
Your battery pack is UNCHARGED and you
must charge once before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
2. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit:
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. C)
Depress the battery release button (6) to
release battery pack from your tool. After
recharging, insert the battery pack into
tool’s battery port. A simple push and slight
pressure will be sufficient.
4. STARTING/STOPPING (See Fig. D)
Starting
Move the On/Off switch (2) to the “I” On
position.
Stopping
Move the On/Off switch (2) to the “O” Off
position.
WARNING! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
5. USING THE BLOWER (See Fig. E)
The blower is intended for residential use
only. Use the blower outdoors to move
debris from hard surfaces. This blower is not
designed to clear leaves from large grassy
areas, or move wet, heavy debris.
USER TIPS
- Hold the blow tube approx 180mm above
the ground when operating the tool.
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a pile,
it is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- Wear safety goggles or other suitable
eye protection, long pants, and shoes.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worx WG594E.3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worx WG594E.3 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info