576052

Worx WG569E.9 Manual

12
Zoom out
Zoom in
Previous page
1/124
Next page
12
Cordless Li-Ion Blower/Sweeper
EN
3. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. C)
Depress the Battery Release Button (9) to
release battery pack from your tool. After
recharging, insert the battery pack into
tool’s battery port. A simple push and slight
pressure will be sufficient.
4.BATTERY STATUS LED’S (See Fig. D )
NOTE: The Status LED’s will indicate the
battery condition when the button on the
battery is pressed.
The LED’s constantly senses and displays the
battery condition as follows:
Press the button “POWERTEST”, the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights ( ) are illuminated, the
battery is in a moderately charged condition.
When only one green light ( ) is illuminated,
the battery charge is depleted.
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged, even
though the blower may still be capable
of blowing debris. Continuing to operate
your blower with the battery in this
discharged condition may reduce the life
and performance of your battery.
5. STARTING/STOPPING (See Fig. E)
Your blower is fitted with a variable speed
control through the trigger. Depress the Lock
OFF switch and the variable speed trigger to
start your blower. To switch off, just release the
variable speed trigger.
WARNING! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
6. USING THE BLOWER (See Fig. F)
The blower is intended for residential use
only. It is fitted with a high speed nozzle. For
wet leaves, use the high speed nozzle for ideal
clean during operating the blower.
USER TIPS
- Hold the blow tube approx 180mm above
the ground when operating the tool.Use
a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a pile,
it is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- Wear safety goggles or other suitable
eye protection, long pants, and
shoes.
CLEANING THE TOOL
CLEAN THE TOOL REGULARLY.
WARNING! Keep your product dry.
Under no circumstances spray with
water.
- To clean the tool, use only mild soap
and a damp cloth.
- Do not use any type of detergent,
cleaner or solvent which may contain
chemicals that could seriously
damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is
not required.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worx WG569E.9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worx WG569E.9 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info