781886
11
Zoom out
Zoom in
Previous page
1/20
Next page
AFTER SALES SUPPORT 15
1300 855 831 support@scheppach.com.au
MODEL: AB1900 PRODUCT CODE: 61755 08/2018
AUS
AB1900 Before starting equipment/Operation
VI. BEFORE STARTING THE EQUIPMENT
Before you connect the equipment to the mains supply make sure that the data on
the rating plate are identical to the mains data.
Always pull the power plug before making adjustments to the equipment.
Check the oil level before using the machine. Place the machine on the oor with
the tool mounting pointing downwards. The oil must be at least above at the middle
of the inspection window (6). (Fig. 1)
Check the drilling point for concealed electrical cables, gas and water pipes using a
cable/pipe detector.
Inserting the accessory (Fig. 1/3)
Clean the accessory before tting it and apply a thin coating of grease (not
included) to the accessory shaft.
Pull out the locking bolt (4) as far as possible, turn it through 180° and release it.
Insert the accessory into the chuck (5) and push it in as far as possible.
Pull out the locking bolt (4) again, turn it through 180° in the opposite direction
and release it.
Check the lock by pulling the accessory.
Removing the accessory
To remove the accessory, proceed in reverse order.
VII. OPERATION
This demolition breaker is designed for use in the breaking of hard surfaces - con-
crete and masonry and for the loosening of impacted dirt and soil. Its powerful motor
and attachments ensure the quick and easy removal of material.
The pointed chisel is used mainly for general chiseling and the demolition of mason-
ry, concrete and loose rock. It is particularly well suited to breaking and loosening.
The at chisel is used for general chiseling, demolition and the breaking of masonry,
concrete and loose stone. With its selective breaking action the at chisel is used for
the removal of protruding concrete and masonry or for the removal residual mortar.
m Important!
To avoid the risk of electric shock, the machine must only be held using the handle
(1) and the auxiliary handle (3). You may suffer an electric shock if you chisel into
electrical cables or power supplies.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Workzone AB1900 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Workzone AB1900 in the language / languages: English as an attachment in your email.

The manual is 2.03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info