809297
7
Zoom out
Zoom in
Previous page
1/16
Next page
7
OPERATION OF
CONTROLS
Operation
Starting up (see fig. 2)
Move the gas control slide to the ignition position. Observe the pilot burner. Press in the
central button of the control slider and hold depressed while pushing the Piezo igniter
button two or three times. The pilot should light. Wait approximately twenty seconds and
then release the centre button of the control slider.
The pilot should remain alight. If the pilot does not light, repeat the operation until a flame
is established.
Note: On initial light up, or after any prolonged shut down, the pilot may take several
attempts to establish due to the presence of air in the gas supply system.
Fig. 2
G661_013
Gas control slide - ignition position
G661_012
Gas control slide - output control (see fig. 3)
After successful ignition move the slide control to the right positioning it according to your
output requirement. The further to the right you position the slide control the higher the
output, and consequently the higher the consumption of gas.
Maximum output is obtained when the slide control is to the far right.
In order to optimize energy consumption, adjust slide control position to supply the
minimum output required.
Fig. 3
output decrease output increase
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch W 125 FL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch W 125 FL in the language / languages: English as an attachment in your email.

The manual is 0.14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info