809348
6
Zoom out
Zoom in
Previous page
1/12
Next page
Installation
MT20 Wired Timer – 6 720 882 947 (2019/07)
6
3.2 Installing the device
3.2.1 Mounting the wall plate
WARNING:
Damage to property!
Damage caused by drilling into pipes, electrical cables or other
hazards.
Ensure that there are no obstructions or other hazards
before drilling.
Position the wall plate near the appliance leaving sufficient
length in the cable to connect to the appliance.
Hold wall plate level to mark securing points and remove
wall plate.
Drill holes, where marked, 30mm deep using a 6mm
diameter drill bit.
Insert the wall plugs
Reposition the wall plate, check level and secure with
screws.
Fig. 4 Wall plate mounting
3.2.2 Fitting the MT20 onto the wall plate
Refer to figure 5.
Cable routing can be done one of two ways, through the
rear cable entry point [7].
-or-
through the knock-out panel [6] at the bottom of the wall
plate [1].
Engage the four locating clips [5] on the back of the MT20
[4] with the four slots on the wall plate [1].
Push the MT20 [4] down into the body of the wall plate [1]
to secure.
Engage the tabs [2] on the top retainer [3] into the slots on
the wall plate [1] and push down onto the MT20 [4] to
secure.
Fig. 5 Fitting the MT20 to the wall plate
0010017912-001
Ø 6 mm
0010018091-001
1 2
3
6
7
5
4
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch MT20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch MT20 in the language / languages: English as an attachment in your email.

The manual is 3.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info