809304

Worcester-Bosch i RSF Manual

6
Zoom out
Zoom in
Previous page
1/16
Next page
6
SHOWERS, BIDETS, TAPS AND MIXING
VALVES
Standard hot and cold taps and mixing valves used with the
appliance must be suitable for operating at the available mains
pressure. Thermostatically controlled or pressure equalising shower
valves will guard against the flow of water at too high a temperature.
Hot and cold mains fed water can be supplied direct to an
overrim flushing bidet subject to local water company requirements.
With all mains fed systems the flow of water from the individual
taps will vary with the number of outlets operated simultaneously
and the cold water mains supply pressure to the property. Flow
balancing using ‘Ball-o-Fix’ type valves is recommended to avoid an
excessive reduction in flow to individual outlets.
For further information contact Worcester Heat Systems Ltd.
HOT AND COLD FLOW
If the flow of water demanded from both hot and cold service
outlets is dependent upon mains supply, it may not be possible in
some installations to operate all outlets simultaneously.
WATER MAINS FAILURE
It is important to note that in the event of a mains water supply
failure, no tap water will be available until the mains supply is
restored.
USE IN HARD WATER AREAS
In temporary hard water areas (more than 350mg/litre or 200ppm
calcium bicarbonate) it is recommended that a proprietary scale
reducer is fitted in the mains cold water connection to the appliance.
Consult the local water company for additional advice.
Installation of a scale inhibitor assembly should be in accordance
with the requirements of the local water company. An isolating valve
should be fitted to allow servicing.
The water hardness can be determined by reference to the local
water company.
DOMESTIC HOT WATER TEMPERATURE
CONTROL
By slightly reducing the flow of domestic water from the tap, the
delivery temperature will be increased. This is of particular advantage
in the winter, for example to increase bath water temperature and to
remove heavy grease deposits on plates, etc. Also this will provide an
added advantage of reducing the delay before hot water is obtained.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch i RSF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch i RSF in the language / languages: English as an attachment in your email.

The manual is 1.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info