8
▲
▲
CENTRAL HEATING TEMPERATURE
CONTROL
The position of this knob will determine the temperature of the
water delivered to the radiators between fully clockwise and anti-
clockwise to the mark. When the knob is turned anti-clockwise
past the position towards the ‘’(Summer Position), then the
appliance will operate in the HOT WATER mode only and no heat will
be delivered to the radiators.
HOT WATER TEMPERATURE CONTROL
There is no separate temperature control.
By slightly reducing the flow of domestic water from the tap, the
delivery temperature of the water will be further increased. This is of
particular advantage in the winter, for example to increase bath water
temperature and to remove heavy grease deposits on plates, etc. Also
this will provide an added advantage of reducing the delay before hot
water is obtained.
FACIA MOUNTED PROGRAMMER (if fitted)
Your installer may have mounted either a mechanical or an
electronic programmer into the facia of your appliance. Operating
instructions are supplied with the programmer.
RESET BUTTON
Press this button in for five seconds if the indicator light is
flashing slowly.
If indicator lamp is flashing fast turn power OFF and ON at the
switched socket supply to reset.
SYSTEM PRESSURE GAUGE
The black needle will show the actual pressure in the system.
When operating the pressure indicated must not be greater than
2.5bar. If it is then contact your installer.
OPERATION OF
CONTROLS
