809235
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
Fault finding
Greenstar Si Compact ErP - 6 720 813 279 (2014/09)
7Fault finding
In the event that the appliance stops functioning or does not perform as expected, please see table below These problems are some
of the most common causes. Should the problem persist or if other fault codes are displayed, then it will be necessary to contact
Worcester, Bosch Group.
This table gives information on basic operating system problems.
Problem Cause Remedy
EA fault code flashing on
display
No gas supply/low gas supply pressure Contact your gas supplier.
Condensate outlet blocked If it is safe to do so, check your condensate pipe
outlet for blockages, such as ice or foreign objects.
Flue blocked If it is safe to do so, check your flue outlet for damage
or blockages.
Desired room
temperature is not
reached
Thermostatic radiator valve(s) set too low Increase thermostatic radiator valve setting(s).
Temperature control for central heating
flow on appliance set too low
Increase central heating flow temperature control
setting
Low temperature setting on the room
thermostat
Increase setting on the room thermostat.
Air trapped in heating system Bleed radiators and re-pressurise the heating system
Low system water pressure Re-pressurise the system, refer to page 11
Desired room
temperature too high
Thermostatic radiator valves are set to high Turn down thermostatic radiator valves.
Room thermostat is set too high ▶Turn down room thermostat.
Radiators are too hot Temperature control on appliance set too
high
Reduce central heating temperature by turning down
the Central Heating control on appliance.
Note: This could prevent your property reaching the
desired temperature during cold weather periods.
Heating stays on for too
long
Clock is incorrectly set Check clock setting and adjust
No blue Operation/Fault
Indicator demand
Momentary power failure Disconnect boiler supply, wait a few seconds then
reconnect.
Heat requirement demand operation on
light has been deactivated
Ask your installer to reset the blue light
Hot water temperature
too low
Temperature set too low on boiler controls Check setting and adjust
Water flow at tap too high Reduce flow rate at tap
Air trapped in heating system Bleed radiators and re-pressurise the heating system
Low system water pressure Re-pressurise the system, refer to page 11
Hot water temperature
too high
Temperature set too high on boiler controls Check setting and adjust
Water flow at tap too low Increase flow rate at tap
Table 3 Fault finding
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar Si Compact 2014-2023 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar Si Compact 2014-2023 in the language / languages: English as an attachment in your email.

The manual is 3.34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info