809350
25
Zoom out
Zoom in
Previous page
1/48
Next page
25
Working with the main menu
Sense ll – 6 720 812 775 (2014/10)
5.3.3 Automatic adaptation of the time program
Menu: Start opt. time prog.
5.3.4 Setting summer/winter switchover threshold
This menu item is only available with weather-compensated
control. In order to be able to use weather-compensated
control, an outside temperature sensor must be installed.
The heating system is switched off in summer mode, the
heating system in switched on in winter mode. DHW heating is
independent of the switching between summer and winter
modes.
Menu: Sum./wint. changeover
5.4 Changing the settings for DHW heating
Menu: DHW
These settings are only available if at least one DHW system is
installed in the system. The water can be heated via a cylinder
or according to the instantaneous water heating principle.
Menu item description
Start opt.
time prog.1)
1) Depending on the installed system, it may be necessary to
select a heating circuit (heating circuit 1-4).
If the cut-in optimisation is switched on,
the heating periods in the time program
are brought forward so that the set room
temperature is reached at the beginning
of the heating period.
If the cut-in optimisation is switched off,
the heating system is switched on at the
required times. The set room
temperature is reached slightly later.
Table 19 Settings for the cut-in optimisation of the time
programs
NOTICE: System damage
Do not switch over to summer mode if
there is a risk of frost.
Switching between summer and winter modes
is only active in automatic mode (by taking
account of the time program). For constant
heating circuits (e.g. for a swimming pool or a
ventilation unit) the the switching between
summer and winter modes is not available.
Menu item description
Sum./wint.
changeover
In summer, heating mode can be switched
off (Permanently summer).
The heating mode can be shut down based
on the outside temperature (Summer
mode from); this is only available if the
automatic mode is active in the heating
circuit.
The heating mode can be active constantly
(Permanently winter). However, the heat
source only goes into operation if it is too
cold inside.
If more than one heating circuit is installed, in-
stead of the above refer to the individual
heating circuit menu.
Summer
operation
from1)
1) This menu item is only displayed if the outdoor-
temperature-dependent switching between summer and
winter modes is active for the heating circuit concerned.
If the adjusted outside temperature2) exceeds
the temperature threshold set here, the
heating system is switched off.
If the adjusted outside temperature falls below
the temperature threshold set here by 1 °C,
the heating system is switched on. In systems
with more than one heating circuit, this setting
always relates to the corresponding heating
circuit in each case.
2) When the outside temperature is adjusted, changes to the
measured outside temperature are delayed and
fluctuations reduced.
Table 20 Settings for switching between summer and winter
modes
WARNING: Risk of scalding!
If thermal disinfection has been activated to
avoid legionella, the hot water is heated once
to in excess of 65 °C. The factory setting for
the hot water temperature is 60 °C. There is a
risk of scalding at the draw-off points if the
temperature is set higher than this.
Make sure that a mixer is installed. If in
doubt, ask your Installer.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar Sense ll at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar Sense ll in the language / languages: English as an attachment in your email.

The manual is 4.46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info