809351
6
Zoom out
Zoom in
Previous page
1/20
Next page
6
Product details
6 720 648 748 (2014/03)
2.2 Technical specifications
2.3 Function as room temperature-dependent controller
The Sense I monitors the room temperature and controls the flow temperature from
the heat source to deliver the required room temperature. Must be used with a
compatible time control.
Load Compensation: The heat output of the heat source changes according to the
deviation between the current and required room temperature. This method of
control is suitable for buildings with one temperature level, e. g. open-plan living
area. There are fewer burner starts and shorter pump runtimes thus increasing
efficiency and reducing fuel consumption. Depending on the connected heat source,
this control mode might possibly be not available.
Flow temperature control: The flow temperature changes according to the
deviation between the current and required room temperature. This method of
control is suitable for major load fluctuations and is suitable for buildings with
different temperature zones. The precision of control is higher and the flow
temperature is limited. This saves fuel.
The pump run times can be reduced with the optimised pump run.
2.4 Function as zone controller
The Sense I can be used as a controller for a maximum of 4 heating circuits without a
higher-level control, in combination with a wiring module (for further information
refer to the technical documentation of the wiring module). For additional time
Technical data
Measurements (W × H × D) 82 × 82 × 23 mm
Rated voltage 10 – 24 V DC
Rated current 4 mA
BUS interface EMS/EMS 2 (2-wire BUS)
Control range 5 – 30 °C
Permiss. ambient temperature 0 – 60 °C
IP rating III
Protection class IP20
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar Sense I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar Sense I in the language / languages: English as an attachment in your email.

The manual is 0.92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info