809240
11
Zoom out
Zoom in
Previous page
1/24
Next page
Operation
11
Greenstar 4000 – 6 720 891 170 (2020/09)
4.3 Symbols on the display
Table 4 Symbols on the display
The heating and hot water system has been set up by the installer to its
optimum settings.
It is advised to make a note of these settings before adjusting so that
you can return to these optimum settings in the future.
4.4 Adjusting the appliance flow temperature
4.4.1 Setting the flow temperature
With underfloor heating systems observe the maximum permissible flow
temperature.
The maximum flow temperature can be adjusted between 30 °C
and 82 °C 1).
Press the (key.
The set maximum flow temperature appears.
Press the or keys to set the desired maximum flow temperature.
Table 5 Maximum flow temperature
The setting is saved automatically after two seconds.
Then the symbol is briefly displayed.
WARNING
Risk of scalding!
This appliance is supplied with the CH control set at approximately
65 °C, a temperature that should be suitable for most installations
that comply with current Building Regulations. When the boiler
switches from CH to DHW, the temperature of the hot water may
briefly exceed the DHW set point if the CH temperature is set higher
than the DHW temperature. If the CH temperature is changed to
above 65 °C, it is advisable to fit a thermostatic mixing valve (TMV) at
the point of use (e.g. before the bath hot tap or shower) to protect
vulnerable people from scalding.
Heating On/Off
Press the ( key.
The set maximum flow temperature appears.
Where a Comfort+ or Comfort+ I RF timer key is fitted the Central
Heating can be turned on with the ok key during an off period
4.5 Setting the DHW heating
Hot water functions are only available when an optional integral diverter
valve kit is fitted.
Setting the DHW temperature
Press the * key.
The set DHW temperature appears.
To set the desired DHW temperature, press the or keys.
The setting is saved automatically after two seconds.
Then the symbol is briefly displayed.
WARNING
Risk of scalding!
This appliance is supplied with the CH control set at approximately
65 °C, a temperature that should be suitable for most installations
that comply with current Building Regulations. When the boiler
switches from CH to DHW, the temperature of the hot water may
briefly exceed the DHW set point if the CH temperature is set higher
than the DHW temperature. If the CH temperature is changed to
above 65 °C, it is advisable to fit a thermostatic mixing valve (TMV) at
the point of use (e.g. before the bath hot tap or shower) to protect
vulnerable people from scalding.
Symbol Explanation
Connection with the Wi-Fi network (only available with
accessories)
Connection with Radio Frequency (RF) transmitter, e.g.
Comfort+ I RF room thermostat (only available with Key
accessories)
Central heating adjustment 1)
On: Heating is on.
auto: Heating is switched on and off according to
programmed times for heating.
Once: Move to the next on or off time and directly switch on
or off heating.
Off: Heating is off.
1) This feature is available the timer Key accessories
Central heating off
Domestic Hot water adjustment
On: Hot water preheat is on
auto 1): Hot water is switched on and off according to
programmed times for hot water.
Once 1): Hot water heating on, from the first programmed
switched-on time to the last programmed switch-off time.
Off (eco): Hot water preheat off (boiler in eco mode)
Hot water off
Displays with the appliance status code and diagnostic
code during a fault condition.
Cleaning mode, locks the screen for 15 seconds to enable
cleaning.
Central heating or hot water can be switched either
permanently on or off.
Energy consumption 2)
- Gas consumption
2) The displayed energy values are estimated based on the internal data of the
appliance. Under real conditions many factors influence the energy consumption
and the displayed energy values differ from the energy values of an energy meter.
The energy values are for information and should not be used for billing
purposes. The energy values can be used to compare the energy consumption
between different days / weeks / months.
kWh
1) The maximum value can be reduced by the service technician.
Flow temperature Sample application
Approx. 50 °C Underfloor heating system
Approx. 65 °C 1)
1) In certain cases, for example, where radiators are undersized or homes are
poorly insulated higher flow temperatures may be required, however, please
refer to the relevant scalding risk advice in this manual.
Radiator heating system
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar 4000 - GR4700i Combi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar 4000 - GR4700i Combi in the language / languages: English as an attachment in your email.

The manual is 4.46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info