697438
34
Zoom out
Zoom in
Previous page
1/64
Next page
34
Flue options
GREENSPRING CWi47 – 6 720 646 322 (2015/04)
7 Flue options
7.1 Flue accessories (diameter in mm)
7.1.1 Concentric pipe admission / exhaustion Ø80/125
mm
8 Electrical connection
All regulation, verification and safety mechanisms have been
rigorously tested in the factory and are ready for use.
8.1 Electrical supply
Supply: 230V - 50 Hz, 140 Watts.
Cable: PVC insulated 0.75 mm
2
(24 x 0.2 mm)
temperature rated to 90
°C.
External 3A fuse to BS1362.
The appliance must be earthed.
This appliance must not be connected to a three phase
supply.
•IP20.
Wiring must comply with the latest IEE wiring regulations.
8.2 Equipotential bonding
8.2.1 Main equipotential bonding
Main equipotential bonding is carried at the origin of the
electrical installation and connected to the main electrical
earthing terminal. Metal pipes can be used as bonding
conductors if joints are metal to metal and electrically
continuous. The IEE Wiring Regulations (BS 7671:2008)
require that extraneous conductive parts must be connected to
the main electrical earth. The main bonding of incoming
DANGER: Make sure that all flue
connections are properly sealed.
Failure to follow this requirement may
cause dangerous exhaust gases to enter
living space which may result causing
personal injury or loss of life.
Description Part number
Standard telescopic flue & terminal
(405 - 600mm)
7-719-003-702
Vertical 1,365mm BF kit (inc. adaptor) 7-719-002-431
Extension flue kit (960mm) 7-719-003-666
90 ° flue bend 7-719-003-664
45 ° flue bend 7-719-003-665
High level horizontal flue adaptor 7-719-002-433
Support bracket kit 7-716-191-174
Flashing - flat roof 7-716-191-090
Flashing - pitched roof 7-716-191-091
Table 12 Flue accessories Ø 80/125mm
NOTICE:
Support the flue at approximately one metre
intervals and at a change of direction, use
suitable brackets and fittings.
CAUTION:
Non accessible flue systems:
Where a flue system is not going to be
accessible, provision must be made for
service and inspection.
Voids containing concealed flues must
have at least one inspection hatch no
less than 300mm square.
Flue joints within the void must not be
more than 1.5m from the edge of the
inspection hatch.
Inspection hatches should be located at
changes of direction.
If this is not possible, bends should be
viewable from both directions.
DANGER: RISK OF ELECTRIC SHOCK!
ISOLATE THE MAINS ELECTRIC SUPPLY
BEFORE STARTING ANY WORK AND
OBSERVE ALL RELEVANT SAFETY
PRECAUTIONS.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch GREENSPRING CWi47 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch GREENSPRING CWi47 in the language / languages: English as an attachment in your email.

The manual is 5,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info