697462
5
Zoom out
Zoom in
Previous page
1/12
Next page
5
Working with the main menu
CS200 – 6720830474 (2015/06)
Main menu
DHW
Temperature settings
DHW
Circulation
Circulation time
Operating mode time prog
Start frequency
My DHW circltn time prog.
Circulation pulse
Thermal disinfection
–Start
Start now
Cancel now
Temperature
–Day
Time of day
Settings
Language
Time of day
Date
Autom. time changeover
Display contrast
Time correction
5.1 Changing the settings for DHW (Domestic Hot
Water)
Menu: DHW
These settings are only available if a DHW system is installed in
the system. The water can be heated via a cylinder or according
to the instantaneous water heating principle.
WARNING:
Risk of scalding!
If thermal disinfection or the daily heat-up has been activated to
avoid legionella, the DHW is heated once to in excess of 60 °C
(e.g. Tuesday night at 02:00).
Only carry out thermal disinfection/daily heat-up outside
normal hours of use.
Make sure that a thermal mixer is installed. If in doubt, ask
your installer.
There is a factory-set custom time program for circulation
( Chapter 5.1.2, page 5).
5.1.1 Setting the DHW temperature
The DHW temperature can be set in this menu.
Menu: Temperature settings
Table 2 Temperature settings for DHW
5.1.2 Settings for the DHW circulation
A DHW circulation pump circulates DHW between the DHW
cylinder and the draw-off point (e.g. sink or bath). This makes
DHW available at the tap more quickly. Settings can be made
determining when, and how often, the DHW circulation pump is
activated.
This menu is only available for systems with DHW circulation
pump.
Menu: Circulation
Table 3 Settings for the circulation
Menu item Description
DHW Desired DHW temperature (15 to 60 °C).
Your installer can change the maximum
value in the service menu.
Menu item Description
Circulation
time
If the circulation pump control is time-
dependent, the DHW circulation pump runs
at regular time intervals according to the
settings under Start frequency.
Start
frequency
The start frequency determines how often
the DHW circulation pump goes into
operation for three minutes every hour (1 ×
3 minutes/h up to 6 × 3 minutes/h) or if it is
constantly in operation. Whatever the case,
circulation is only active during the times set
in the time program.
Operating
mode time
prog
Circulation can be switched off
permanently (Off). If this setting is set to
On, the pump will run according to the
settings under "Start frequency".
Using Own time program a time program
can be set for the DHW circulation pump.
My DHW
circltn time
prog.
6 switching times (on/off times) can be set
for each day or group of days. The DHW
circulation pump can be switched on or off at
each switching time. The minimum duration
between two switching times is 15 minutes.
Circulation
pulse
If the circulation control is pulse-dependent,
the circulation is switched on for 3 minutes
after a hot water usage at the tap.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch CS 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch CS 200 in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Worcester-Bosch CS 200

Worcester-Bosch CS 200 Installation Guide - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info