809301
9
Zoom out
Zoom in
Previous page
1/16
Next page
Operating the appliance
9
Worcester 2000 – 6 721 814 552 (2019/09)
4.3 Screen display
Fig. 6 Screen display
Table 3
The heating and hot water system has been set up by the installer to its
optimum settings.
It is advised to make a note of these settings before adjusting so that
you can return to these optimum settings in the future.
4.4 Setting the flow temperature
The maximum flow temperature can be adjusted between 30 °C
and 82 °C. The current flow temperature is shown on the display.
Press the ( key.
The set maximum flow temperature is displayed.
Press arrow key or to set the required maximum flow
temperature.
Press the OK key to save. Otherwise the setting will be saved
automatically after 3 seconds.
The display shows the current flow temperature.
The ( symbol flashes in the display in heating mode. The B symbol
also appears if the burner is active.
4.5 Setting the DHW heating
4.5.1 Set DHW temperature
DHW temperature:
Press the * key.
The set DHW temperature is displayed.
Press arrow key or to set the required DHW temperature
Press the OK key to save. Otherwise the setting will be saved
automatically after 3 seconds.
The display shows the current flow temperature.
The * symbol flashes in the display in DHW mode. The B symbol also
appears if the burner is active.
4.5.2 Setting comfort mode or ECO mode
In comfort mode, the appliance is continually maintained at the set
temperature. This means there will be a shorter delay when drawing
DHW. However, the device will switch on even if no DHW is being drawn.
In ECO mode, heating-up to the set temperature begins as soon as the
DHW is being drawn.
In Eco mode, to reduce water usage:
Briefly open and close the DHW tap.
The water is heated once to the set temperature.
To set ECO mode: press eco until eco appears in the display.
To return to comfort mode: press the eco key until eco vanishes from
the display.
4.6 Setting summer mode
The heating pump and consequently the heating are switched off in
summer mode. The DHW supply and also the power supply for heating
controls and timer remain active.
NOTICE:
Risk of the system freezing.
Frost protection is not available in summer mode.
If there is a risk of frost, exit summer mode ( Chapter 6.1).
To activate summer mode:
Press the ( key.
Keep pressing the arrow key until appears in the display.
Press the OK key to save. Otherwise the setting will be saved
automatically after 3 seconds.
] is permanently displayed.
Further notices can be found in the operating instructions for the heating
control.
Key Explanation
[1] Digital display
Displays a temperature or appliance status/diagnostic code.
[2] Central heating (CH)
( Heating mode On
] Heating mode Off
[3] Fault indicator
Displays during a fault condition.
[4] Burner operation
Displays when the appliance is firing during a CH/DHW
mode.
[5] Internet connected (accessory)
Displays when compatible controller is connected to the
appliance (not used).
[6] Radio link connected (accessory)
Displays when compatible controller is connected to the
appliance.
[7] Chimney sweep mode
Displays during service when the appliance is set to
maximum or minimum output.
[8] Service mode
Displays when a qualified service engineer is in the service
menus.
[9] Eco mode active
Displays when in Economy mode (DHW Pre-heat/comfort
function is turned off)
[10] Domestic hot water (DHW)
* Hot water mode On
0010016015-003
10 9
21 3 4 5 6
8 7
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch 2000 - GC2000iW C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch 2000 - GC2000iW C in the language / languages: English as an attachment in your email.

The manual is 2.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info