742993
50
Zoom out
Zoom in
Previous page
1/63
Next page
HOW TO CALIBRATE THE REMOTE CONTROL:
Before you can use the remote control, you must calibrate it to the extractor
hood. Proceed as follows:
1. The extractor hood must be in STAND - BY MODE (display indicates « 0 » /
illuminant is switched off).
2. Press and hold the button on the extractor hood for 3 seconds to
activate the calibration mode.
3. The button on the extractor hood flashes to indicate that the calibration
mode is activated.
4. In calibration mode press the button (1) on the remote control briefly.
5. When the calibration is successful, an acoustic signal sounds.
If the calibration is unsuccessful, the extractor hood returns to STAND - BY
MODE. In this case, repeat the calibration.
After 15 seconds, without further operation of the button (4), the extractor
hood also returns to STAND - BY MODE.
HOW TO OPERATE THE REMOTE CONTROL:
BUTTON: ON / OFF
Press the button (1) on the remote control to switch on / off the motor of
the extractor hood.
BUTTON TO DECREASE THE POWER LEVEL / MOTOR SPEED
Press the button (2) on the remote control to decrease the power
level / motor speed of the extractor hood (s. chapter 4.4 POWER LEVELS).
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wolkenstein W I2-70A BTZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wolkenstein W I2-70A BTZ in the language / languages: English, German as an attachment in your email.

The manual is 8,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info