742983
27
Zoom out
Zoom in
Previous page
1/44
Next page
27
3. Remove the complete packaging materials before initial operation. The
appliance may be equipped with a transportation lock. Remove the
transportation lock completely. When removing be very careful. Do not use any
aggressive detergents to remove residues of the transportation lock.
4. Clean and maintain the appliance regularly to enable its proper operation and
optimal performance.
5. Take the enclosed parts from the packaging and its polystyrene-
components.
6. Check that the p
ower c
ord and the appliance are not damaged before electrical
connection.
2. Installation
1. The diameter of the exhaust hose must meet the diameter of the connecting
ring.
2. If your appliance is equipped with a carbon filter, remove the carbon filter
before you operate the appliance in the extraction mode. The carbon filter
should be used in the recirculating mode only.
3. The exhaust duct should be as short and straight as possible. The diameter of
the exhaust hose should be at least 150 mm (look at chapter T
ECHNICAL
DATA). Otherwise you have to expect increased noise and decreased
performance of your appliance.
4. The proper maximum bending angle outwards is 120
0
.
5. Use smooth tubes or flexible, non-inflammable exhaust hoses only.
6. When the exhaust duct is connected horizontally, a minimum falling gradient of
1 cm/m or an inclination of 2
0
is required. Otherwise condensate will get into
the motor of the hood.
7. When an exhaust duct is used, the ending of the exhaust hose must be adjusted
into the direction of flow.
8.
If the exhaust duct passes through cool areas (e.g. an attic), a temperature
gradient may occur in the different parts of the exhaust duct so condensate will
be generated. Proper insulation of the corresponding parts of the exhaust duct
will then be needed. Equip such an exhaust duct with a condensate trap if need
be.
9. Depending on the model the hood is equipped with one ( top ) or two ( top,
back ) outlets.
10. The idle outlet is covered by a plastic cap. You can remove
this cap by
turning it
anticlockwise. Use the cap to cover the idle outlet.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wolkenstein SL S13-60 ABT2X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wolkenstein SL S13-60 ABT2X in the language / languages: English, German as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info