799044
12
Zoom out
Zoom in
Previous page
1/86
Next page
12 G
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
The machine operates from any normal household mains sup-
ply.
3Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
Adjust operating depth
1Caution! Only with motor switched off and non-mowing
scarifying / aerating roller.
1Caution! The working depth must be set correctly befo-
re the unit is used for the first time. The hight adjust-
ment lever may be moved to the first working depth
setting only (position „1“)
3Note
If the blades/aerator tines are worn, the working depth must
be readjusted subsequently. An optimum working depth is
obtained when the blades/aerator tines of the cutter are in-
serted 2–3 mm into the ground.
If the working depth is too great, the unit may be overloaded
and cause damage. Therefore, ensure that the working
depth is set correctly.
Increasing the working depth (cutters towards the
ground) (a, b)
Set height adjustment lever (depending on model) accor-
ding to wear.
Settings pos. „2, 3, 4“ are not required until the blades/aera-
tor tines are worn. Depending on the degree of wear, gradu-
ally set the blades lower, starting at pos. „2“.
Reducing the working depth (a, c)
3Scarifying / aerating test:
Set height adjustment lever in working position „1, 2, 3,
4“ .
Start tool
On hearing stones being hit or blocking of the motor im-
mediately switch off tool
Reducing the working depth : Set height adjust-
ment lever in working position „1, 2, 3, 4“.
Start scarifying / aerating test again
When used regularly the working depth may be adjusted ac-
cording to the wear of the blade (+).
Recommended working heights
well kept lawns with stone-free, soft ground
Set tool exactly to ground height
stony, untidy lawns
Set tool to ground height
Increase working height if stones are thrown up
unkempt, extremely mossy lawns
Start with a high working height
Do not overload appliance (reduce working height if motor
blocks)
Cut vertically and crossways several times
Scarifying / aerating
1. Depress button (1) and hold.
2. Lift up bar (2) and release button (1).
3. Switch-off motor: Release bar (2).
1Important:
Place the cable firmly off the lawn or on the already cut side
of the lawn when starting to mow.
Maintenance
General
1Attention! Rotary cutter blade
Before all maintenance and cleaning work:
pull out the power plug.
Do not touch running blades.
Cleaning
Clean the unit thoroughly with a brush after each use.
Do not spray with water.
Store unit in a dry room.
3We recommend
Allow a WOLF-Garten-service centre to check the unit in the
autumn.
E
J
J
G
J
G
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten VS 302 E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten VS 302 E in the language / languages: All languages as an attachment in your email.

The manual is 9.18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info