638376

WOLF-Garten UV 30 EV plus Manual

13
Zoom out
Zoom in
Previous page
1/30
Next page
12
13
Maintenance
Maintenance
Remove spark plug/mains plug cap before attemting any
work to the unit.
Clean the unit thoroughly with a brush after each use. Do not
spray with water. Store unit in a dry room.
We recommend
Allow a WOLF-service centre to check the unit in the
autumn.
Operation
Adjust operating depth (Fig. B)
Only with motor switched off and non-mowing aeriating roller.
The operating depth must be adjusted to the corresponding
grass and ground conditions.
• Move operating lever towards front (Fig. B, 1).
•
Adjust operating depth with turn handle to the desired depth (+).
Aeriating test:
- Pull operating lever up again.
- Start tool (Fig. C).
- Push operating lever slowly forward (Fig. D).
- Move tool slowly into operating direction.
- On hearing stones being hit or blocking of the motor imme-
diately switch off tool.
- Turn rotating handle 1–2 rotations towards the left (–) - (One
revolution corresponds to 1,5 mm.)
- Start aeriating test again.
• When used regularly the aeriating depth may be adjusted
according to the wear of the blade (+).
Recommended working heights
well kept lawns with stone-free, soft ground
• Set tool exactly to ground height
stony, untidy lawns
• Set tool to ground height
• Increase working height if stones are thrown up
unkempt, extremely mossy lawns
• Start with a high working height
• Do not overload appliance (increase working height if motor
blocks)
• Cut vertically and crossways several times
• Re-sow with WOLF >>Loretta<< lawn seeds
Attach grassbox* (Fig. F)
Lift protective ap, hook grassbox with the hooks provided into
the holes in the chassis (see arrow), reattach protective ap.
*Grassbox TK-VV 3632 060 - (accessory, available at
additional cost)
Starting up the engine/Scarifying
1. Depress button (Fig. C, 1) and hold.
2. Lift up bar (Fig. C, 2) and release button (Fig. C, 1).
3. Place lever (Fig. D) slowly into forward position.
4. Switch-off motor: Release bar (Fig. C, 2).
Important: Place the cable rmly off the lawn or on the
already cut side of the lawn when starting to mow.
Turning (UV 32 EV, UV 34 E)
The cable relief holder enables you to move the cable from
one side of the handle frame to the other. Thus you ensure
that the cable always trails on the ride of the lawn already cut
– and not in front of the machine (Fig. E).
Operating times
Please check noise abatement regulations prevailing in your
country.
Connecting to the mains (230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains
supply, provided with a 16 Amps. fuse.
Note: Use a residual current device (RCD) rated for a
residual current not greater than 30 mA.
Inserting power cable into cable holder (Fig. A)
Insert the power cord into the strain relief as shown in the
illustration.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten UV 30 EV plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten UV 30 EV plus in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Turkish, Norwegian, Finnish as an attachment in your email.

The manual is 3,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info